[PATCH v6 13/13] mtd: rawnand: brcmnand: Support write protection setting from dts

[William Zhang]

The write protection feature is controlled by the module parameter wp_on
with default set to enabled. But not all the board use this feature
especially in BCMBCA broadband board. And module parameter is not
sufficient as different board can have different option.  Add a device
tree property and allow this feature to be configured through the board
dts on per board basis.

Signed-off-by: William Zhang <william.zhang at broadcom.com>
Reviewed-by: Florian Fainelli <florian.fainelli at broadcom.com>
Reviewed-by: Kamal Dasu <kamal.dasu at broadcom.com>
Reviewed-by: David Regan <dregan at broadcom.com>

---

Changes in v6: None
Changes in v5: None
Changes in v4:
- Use the new brcm,wp-not-connected property based on the dts binding
change

Changes in v3: None
Changes in v2: None

 drivers/mtd/nand/raw/brcmnand/brcmnand.c | 4 ++++
 1 file changed, 4 insertions(+)

diff --git a/drivers/mtd/nand/raw/brcmnand/brcmnand.c b/drivers/mtd/nand/raw/brcmnand/brcmnand.c
index e8ffc283b365..4810345d0d8a 100644
--- a/drivers/mtd/nand/raw/brcmnand/brcmnand.c
+++ b/drivers/mtd/nand/raw/brcmnand/brcmnand.c
@@ -3223,6 +3223,10 @@ int brcmnand_probe(struct platform_device *pdev, struct brcmnand_soc *soc)
 	/* Disable XOR addressing */
 	brcmnand_rmw_reg(ctrl, BRCMNAND_CS_XOR, 0xff, 0, 0);
 
+	/* Check if the board connects the WP pin */
+	if (of_property_read_bool(dn, "brcm,wp-not-connected"))
+		wp_on = 0;
+
 	if (ctrl->features & BRCMNAND_HAS_WP) {
 		/* Permanently disable write protection */
 		if (wp_on == 2)
-- 
2.37.3