[PATCH v2 2/2] mtd: spinand: micron: fixing the offset for OOB

[Martin Kurbanov]

Hi Miquel,

On 24.08.2023 12:35, Martin Kurbanov wrote:
> 
> 
> On 23.08.2023 14:39, Miquel Raynal wrote:
>> Hi Martin,
>>
>> mmkurbanov at sberdevices.ru wrote on Wed, 23 Aug 2023 14:33:57 +0300:
>>
>>> Hi Miquel,
>>>
>>> On 23.08.2023 11:41, Miquel Raynal wrote:
>>>> Hi Martin,
>>>>
>>>> I don't think the four bytes have any "bad block specific" meaning. In
>>>> practice, the datasheet states:
>>>>
>>>> 	Value programmed for bad block at the first byte of spare
>>>> 	area: 00h
>>>>
>>>> So only the first byte is used to mark the block bad, the rest is
>>>> probably marked "reserved" for simplicity. I believe we should keep the
>>>> current layout because it would otherwise break users for no real
>>>> reason.  
>>>
>>> I agree with you that this can break the work of users who use OOB.
>>> However, I believe it would be more appropriate to use an offset of 4,
>>> as the micron chip can use all 4 bytes for additional data about the
>>> bad block. So, there is a non-zero probability of losing OOB data in
>>> the reserved area (2 bytes) when the hardware chip attempts to mark
>>> the block as bad.
>>
>> Is this really a process the chip can do? Aren't bad blocks factory
>> marked only?
> 
> Actually, there is my understanding, I’m not sure exactly.

I tested with an offset of 2, no read/write errors were detected
(including read/write to OOB). But I don't have a flash chip with
factory bad blocks yet, when I find such a flash, I will report the
results.
Do I need to send the v3 of the patch with only first commit ("correct
bitmask for ecc status")?

-- 
Best Regards,
Martin Kurbanov