[PATCH v2 2/2] mtd: spi-nor: Add support for flash reset

[Michael Walle]

Am 2022-09-01 09:29, schrieb Sai Krishna Potthuri:
> Add support for spi-nor flash reset via GPIO controller by reading the
> reset-gpio property. If there is a valid GPIO specifier then reset will
> be performed by asserting and deasserting the GPIO using gpiod APIs
> otherwise it will not perform any operation.
> 
> Signed-off-by: Sai Krishna Potthuri <sai.krishna.potthuri at amd.com>

Reviewed-by: Michael Walle <michael at walle.cc>

Just one comment, see below

> ---
>  drivers/mtd/spi-nor/core.c | 25 +++++++++++++++++++++++++
>  1 file changed, 25 insertions(+)
> 
> diff --git a/drivers/mtd/spi-nor/core.c b/drivers/mtd/spi-nor/core.c
> index f2c64006f8d7..a78ab9bae2be 100644
> --- a/drivers/mtd/spi-nor/core.c
> +++ b/drivers/mtd/spi-nor/core.c
> @@ -2933,6 +2933,27 @@ static void spi_nor_set_mtd_info(struct spi_nor 
> *nor)
>  	mtd->_put_device = spi_nor_put_device;
>  }
> 
> +static int spi_nor_hw_reset(struct spi_nor *nor)
> +{
> +	struct gpio_desc *reset;
> +
> +	reset = devm_gpiod_get_optional(nor->dev, "reset", GPIOD_OUT_LOW);
> +	if (IS_ERR_OR_NULL(reset))
> +		return PTR_ERR_OR_ZERO(reset);
> +
> +	/*
> +	 * Experimental delay values by looking at different flash device
> +	 * vendors datasheets.
> +	 */
> +	usleep_range(1, 5);

I think this is superfluous, because parts of the kernel
will boot which should take longer than 1us. But I'm
fine with leaving it here.

-michael

> +	gpiod_set_value_cansleep(reset, 1);
> +	usleep_range(100, 150);
> +	gpiod_set_value_cansleep(reset, 0);
> +	usleep_range(1000, 1200);
> +
> +	return 0;
> +}
> +
>  int spi_nor_scan(struct spi_nor *nor, const char *name,
>  		 const struct spi_nor_hwcaps *hwcaps)
>  {
> @@ -2965,6 +2986,10 @@ int spi_nor_scan(struct spi_nor *nor, const char 
> *name,
>  	if (!nor->bouncebuf)
>  		return -ENOMEM;
> 
> +	ret = spi_nor_hw_reset(nor);
> +	if (ret)
> +		return ret;
> +
>  	info = spi_nor_get_flash_info(nor, name);
>  	if (IS_ERR(info))
>  		return PTR_ERR(info);