[PATCH 12/13] mtd: spinand: Perform Power-on-Reset when runtime_pm suspend is issued

[Apurva Nandan]

A soft reset using FFh command doesn't erase the flash's configuration
and doesn't reset the SPI IO mode also. This can result in the flash
being in a different SPI IO mode, e.g. Octal DTR, when resuming from
sleep. This would render the flash in an unusable state.

Perform a Power-on-Reset (PoR), if available in the flash, when
suspending the device by runtime_pm. This would set the flash to clean
state for reinitialization during resume and would also ensure that it
is in standard SPI IO mode (1S-1S-1S) before the resume begins.

Signed-off-by: Apurva Nandan <a-nandan at ti.com>
---
 drivers/mtd/nand/spi/core.c | 16 ++++++++++++++++
 1 file changed, 16 insertions(+)

diff --git a/drivers/mtd/nand/spi/core.c b/drivers/mtd/nand/spi/core.c
index 608f4eb85b0a..6fb3aa6af540 100644
--- a/drivers/mtd/nand/spi/core.c
+++ b/drivers/mtd/nand/spi/core.c
@@ -1329,6 +1329,21 @@ static void spinand_mtd_resume(struct mtd_info *mtd)
 	spinand_ecc_enable(spinand, false);
 }
 
+static int spinand_mtd_suspend(struct mtd_info *mtd)
+{
+	struct spinand_device *spinand = mtd_to_spinand(mtd);
+	int ret;
+
+	if (!(spinand->flags & SPINAND_HAS_POR_CMD_BIT))
+		return 0;
+
+	ret = spinand_power_on_rst_op(spinand);
+	if (ret)
+		dev_err(&spinand->spimem->spi->dev, "suspend() failed\n");
+
+	return ret;
+}
+
 static int spinand_init(struct spinand_device *spinand)
 {
 	struct device *dev = &spinand->spimem->spi->dev;
@@ -1401,6 +1416,7 @@ static int spinand_init(struct spinand_device *spinand)
 	mtd->_erase = spinand_mtd_erase;
 	mtd->_max_bad_blocks = nanddev_mtd_max_bad_blocks;
 	mtd->_resume = spinand_mtd_resume;
+	mtd->_suspend = spinand_mtd_suspend;
 
 	if (nand->ecc.engine) {
 		ret = mtd_ooblayout_count_freebytes(mtd);
-- 
2.17.1