[PATCH v2 2/3] mtd: spi-nor: Altera ASMI Parallel II IP Core

matthew.gerlach at linux.intel.com matthew.gerlach at linux.intel.com
Wed Oct 11 10:00:37 PDT 2017



On Tue, 10 Oct 2017, Marek Vasut wrote:

> On 09/20/2017 08:28 PM, matthew.gerlach at linux.intel.com wrote:
>> From: Matthew Gerlach <matthew.gerlach at linux.intel.com>
>>
>> This patch adds support for a spi-nor, platform driver for the
>> Altera ASMI Parallel II IP Core.  The intended use case is to be able
>> to update the flash used to load a FPGA at power up with mtd-utils.
>>
>> Signed-off-by: Matthew Gerlach <matthew.gerlach at linux.intel.com>
>> ---
>> v2:
>>     minor checkpatch fixing by Wu Hao <hao.wu at intel.com>
>>     Use read_dummy value as suggested by Cyrille Pitchen.
>>     Don't assume 4 byte addressing (Cryille Pichecn and Marek Vasut).
>>     Fixed #define indenting as suggested by Marek Vasut.
>>     Added units to timer values as suggested by Marek Vasut.
>>     Use io(read|write)8_rep() as suggested by Marek Vasut.
>>     Renamed function prefixed with __ as suggested by Marek Vasut.
>
> [...]
>
>> +#define QSPI_ACTION_REG			0
>> +#define QSPI_ACTION_RST			BIT(0)
>> +#define QSPI_ACTION_EN			BIT(1)
>> +#define QSPI_ACTION_SC			BIT(2)
>> +#define QSPI_ACTION_CHIP_SEL_SFT	4
>> +#define QSPI_ACTION_DUMMY_SFT		8
>> +#define QSPI_ACTION_READ_BACK_SFT	16
>> +
>> +#define QSPI_FIFO_CNT_REG		4
>> +#define QSPI_FIFO_DEPTH			0x200
>> +#define QSPI_FIFO_CNT_MSK		0x3ff
>> +#define QSPI_FIFO_CNT_RX_SFT		0
>> +#define QSPI_FIFO_CNT_TX_SFT		12
>> +
>> +#define QSPI_DATA_REG			0x8
>> +
>> +#define QSPI_POLL_TIMEOUT_US		10000000
>
> 10 s poll timeout ? :)

Hi Marek,

The 10s timeout is fairly arbitrary.  In other words, I pulled it out of 
thin air.  Can you suggest a better timeout?  From a practical standpoint 10s 
seemed to be much better than no timeout when I was debugging bad FPGA 
images.  Without a timeout I was hanging the system when the FPGA image 
failed.  With this timeout, we get a nice message and Linux keeps running 
happily.

Thanks for the feedback,

Matthew Gerlach

>
>> +#define QSPI_POLL_INTERVAL_US		 5 >> + >> +struct 
altera_asmip2 { >
> [...]
>
> Otherwise looks good
>
> -- 
> Best regards,
> Marek Vasut
>



More information about the linux-mtd mailing list