[PATCH v2 2/3] mtd: spi-nor: Altera ASMI Parallel II IP Core

[Marek Vasut]

On 09/20/2017 08:28 PM, matthew.gerlach at linux.intel.com wrote:
> From: Matthew Gerlach <matthew.gerlach at linux.intel.com>
> 
> This patch adds support for a spi-nor, platform driver for the
> Altera ASMI Parallel II IP Core.  The intended use case is to be able
> to update the flash used to load a FPGA at power up with mtd-utils.
> 
> Signed-off-by: Matthew Gerlach <matthew.gerlach at linux.intel.com>
> ---
> v2:
>     minor checkpatch fixing by Wu Hao <hao.wu at intel.com>
>     Use read_dummy value as suggested by Cyrille Pitchen.
>     Don't assume 4 byte addressing (Cryille Pichecn and Marek Vasut).
>     Fixed #define indenting as suggested by Marek Vasut.
>     Added units to timer values as suggested by Marek Vasut.
>     Use io(read|write)8_rep() as suggested by Marek Vasut.
>     Renamed function prefixed with __ as suggested by Marek Vasut.

[...]

> +#define QSPI_ACTION_REG			0
> +#define QSPI_ACTION_RST			BIT(0)
> +#define QSPI_ACTION_EN			BIT(1)
> +#define QSPI_ACTION_SC			BIT(2)
> +#define QSPI_ACTION_CHIP_SEL_SFT	4
> +#define QSPI_ACTION_DUMMY_SFT		8
> +#define QSPI_ACTION_READ_BACK_SFT	16
> +
> +#define QSPI_FIFO_CNT_REG		4
> +#define QSPI_FIFO_DEPTH			0x200
> +#define QSPI_FIFO_CNT_MSK		0x3ff
> +#define QSPI_FIFO_CNT_RX_SFT		0
> +#define QSPI_FIFO_CNT_TX_SFT		12
> +
> +#define QSPI_DATA_REG			0x8
> +
> +#define QSPI_POLL_TIMEOUT_US		10000000

10 s poll timeout ? :)

> +#define QSPI_POLL_INTERVAL_US		5
> +
> +struct altera_asmip2 {

[...]

Otherwise looks good

-- 
Best regards,
Marek Vasut