[PATCH] mtd: nand: hynix: Don't wait after applying new read-retry params

[Boris Brezillon]

On Mon, 13 Nov 2017 10:59:01 +0100
Boris Brezillon <boris.brezillon at free-electrons.com> wrote:

> Setting read-retry parameters has no impact on the R/B pin, so waiting
> for the chip to be ready is useless.

Applied.

> 
> Signed-off-by: Boris Brezillon <boris.brezillon at free-electrons.com>
> ---
>  drivers/mtd/nand/nand_hynix.c | 5 -----
>  1 file changed, 5 deletions(-)
> 
> diff --git a/drivers/mtd/nand/nand_hynix.c b/drivers/mtd/nand/nand_hynix.c
> index 985751eda317..72d98cbff4ca 100644
> --- a/drivers/mtd/nand/nand_hynix.c
> +++ b/drivers/mtd/nand/nand_hynix.c
> @@ -83,7 +83,6 @@ static int hynix_nand_setup_read_retry(struct mtd_info *mtd, int retry_mode)
>  	struct nand_chip *chip = mtd_to_nand(mtd);
>  	struct hynix_nand *hynix = nand_get_manufacturer_data(chip);
>  	const u8 *values;
> -	int status;
>  	int i;
>  
>  	values = hynix->read_retry->values +
> @@ -112,10 +111,6 @@ static int hynix_nand_setup_read_retry(struct mtd_info *mtd, int retry_mode)
>  	/* Apply the new settings. */
>  	chip->cmdfunc(mtd, NAND_HYNIX_CMD_APPLY_PARAMS, -1, -1);
>  
> -	status = chip->waitfunc(mtd, chip);
> -	if (status & NAND_STATUS_FAIL)
> -		return -EIO;
> -
>  	return 0;
>  }
>