[PATCH] mtd: nand: hynix: Don't wait after applying new read-retry params

[Boris Brezillon]

Setting read-retry parameters has no impact on the R/B pin, so waiting
for the chip to be ready is useless.

Signed-off-by: Boris Brezillon <boris.brezillon at free-electrons.com>
---
 drivers/mtd/nand/nand_hynix.c | 5 -----
 1 file changed, 5 deletions(-)

diff --git a/drivers/mtd/nand/nand_hynix.c b/drivers/mtd/nand/nand_hynix.c
index 985751eda317..72d98cbff4ca 100644
--- a/drivers/mtd/nand/nand_hynix.c
+++ b/drivers/mtd/nand/nand_hynix.c
@@ -83,7 +83,6 @@ static int hynix_nand_setup_read_retry(struct mtd_info *mtd, int retry_mode)
 	struct nand_chip *chip = mtd_to_nand(mtd);
 	struct hynix_nand *hynix = nand_get_manufacturer_data(chip);
 	const u8 *values;
-	int status;
 	int i;
 
 	values = hynix->read_retry->values +
@@ -112,10 +111,6 @@ static int hynix_nand_setup_read_retry(struct mtd_info *mtd, int retry_mode)
 	/* Apply the new settings. */
 	chip->cmdfunc(mtd, NAND_HYNIX_CMD_APPLY_PARAMS, -1, -1);
 
-	status = chip->waitfunc(mtd, chip);
-	if (status & NAND_STATUS_FAIL)
-		return -EIO;
-
 	return 0;
 }
 
-- 
2.11.0