[PATCH v1 3/5] mtd: atmel_nand: Support PMECC on SAMA5D2

[Rob Herring]

On Wed, Jan 13, 2016 at 7:17 PM, Yang, Wenyou <Wenyou.Yang at atmel.com> wrote:
>
>
>> -----Original Message-----
>> From: Rob Herring [mailto:robh at kernel.org]
>> Sent: 2016年1月14日 9:13
>> To: Romain Izard <romain.izard.pro at gmail.com>
>> Cc: linux-mtd at lists.infradead.org; devicetree at vger.kernel.org; Yang, Wenyou
>> <Wenyou.Yang at atmel.com>; Josh Wu <rainyfeeling at outlook.com>; Ferre,
>> Nicolas <Nicolas.FERRE at atmel.com>
>> Subject: Re: [PATCH v1 3/5] mtd: atmel_nand: Support PMECC on SAMA5D2
>>
>> On Wed, Jan 13, 2016 at 05:34:15PM +0100, Romain Izard wrote:
>> > Starting with the SAMA5D2, there is a new revision of the Atmel PMECC
>> > controller that can correct 32 bits in each sector. This controller is
>> > not 100% compatible with the previous revision that corrected a
>> > maximum of 24 bits by sector, as some register addresses overlap.
>> >
>> > Using information from the device tree, we can configure the driver to
>> > work with both versions.
>> >
>> > Signed-off-by: Romain Izard <romain.izard.pro at gmail.com>
>> > ---
>> >  .../devicetree/bindings/mtd/atmel-nand.txt         |  7 +++++--
>> >  drivers/mtd/nand/atmel_nand.c                      | 23 +++++++++++++++++++++-
>> >  drivers/mtd/nand/atmel_nand_ecc.h                  |  8 ++++++--
>> >  3 files changed, 33 insertions(+), 5 deletions(-)
>> >
>> > diff --git a/Documentation/devicetree/bindings/mtd/atmel-nand.txt
>> > b/Documentation/devicetree/bindings/mtd/atmel-nand.txt
>> > index 89b0db9801b0..90887b430f03 100644
>> > --- a/Documentation/devicetree/bindings/mtd/atmel-nand.txt
>> > +++ b/Documentation/devicetree/bindings/mtd/atmel-nand.txt
>> > @@ -1,7 +1,10 @@
>> >  Atmel NAND flash
>> >
>> >  Required properties:
>> > -- compatible : should be "atmel,at91rm9200-nand" or "atmel,sama5d4-nand".
>> > +- compatible: The possible values are:
>> > +   "atmel,at91rm9200-nand"
>> > +   "atmel,sama5d2-nand"
>> > +   "atmel,sama5d4-nand"
>> >  - reg : should specify localbus address and size used for the chip,
>> >     and hardware ECC controller if available.
>> >     If the hardware ECC is PMECC, it should contain address and size for
>> > @@ -22,7 +25,7 @@ Optional properties:
>> >    Supported values are: "none", "soft", "hw", "hw_syndrome", "hw_oob_first",
>> >    "soft_bch".
>> >  - atmel,has-pmecc : boolean to enable Programmable Multibit ECC hardware.
>> > -  Only supported by at91sam9x5 or later sam9 product.
>> > +  Supported by AT91SAM9x5 or later SAM9 chips, and SAMA5 chips.
>>
>> What compatible string would AT91SAM9x5 be?
>
> "atmel,at91rm9200-nand".

Answer the question in the binding doc by saying which compatible
strings a property is valid for.

Rob