[PATCH V10 2/2] mtd: spi-nor: Add driver for Cadence Quad SPI Flash Controller.

Marek Vasut marex at denx.de
Tue Jan 12 05:49:49 PST 2016


On Tuesday, January 12, 2016 at 05:41:02 AM, Vignesh R wrote:
> On 01/11/2016 09:39 PM, Dinh Nguyen wrote:
> > On 01/10/2016 10:34 PM, Marek Vasut wrote:
> >> From: Graham Moore <grmoore at opensource.altera.com>
> >> 
> >> Add support for the Cadence QSPI controller. This controller is
> >> present in the Altera SoCFPGA SoCs and this driver has been tested
> >> on the Cyclone V SoC.
> 
> [...]
> 
> >> diff --git a/drivers/mtd/spi-nor/Kconfig b/drivers/mtd/spi-nor/Kconfig
> >> index 43bafde..7e29050 100644
> >> --- a/drivers/mtd/spi-nor/Kconfig
> >> +++ b/drivers/mtd/spi-nor/Kconfig
> >> @@ -50,4 +50,15 @@ config SPI_NXP_SPIFI
> >> 
> >>  	  Flash. Enable this option if you have a device with a SPIFI
> >>  	  controller and want to access the Flash as a mtd device.
> >> 
> >> +config SPI_CADENCE_QUADSPI
> >> +	tristate "Cadence Quad SPI controller"
> >> +	depends on OF && (ARCH_SOCFPGA || COMPILE_TEST)
> > 
> > I think you can remove the ARCH_SOCFPGA dependency as this driver is
> > used on a TI EVM as well.
> 
> I think above usage is correct. This will enable SPI_CADENCE_QUADSPI to
> be selected when ARCH_SOCFPGA=y without having to enable COMPILE_TEST.
> AFAIK, COMPILE_TEST is used usually to build test the driver w/o having
> to enable ARCH specific configs (usually by maintainers).
> For TI EVM, I would patch this file to add my architecture later(i.e
> along with DT patch to my board).

I changed this to OF && (ARM || COMPILE_TEST) , so that should be enough.

Best regards,
Marek Vasut



More information about the linux-mtd mailing list