[PATCH V10 2/2] mtd: spi-nor: Add driver for Cadence Quad SPI Flash Controller.

[Vignesh R]

On 01/11/2016 09:39 PM, Dinh Nguyen wrote:
> On 01/10/2016 10:34 PM, Marek Vasut wrote:
>> From: Graham Moore <grmoore at opensource.altera.com>
>>
>> Add support for the Cadence QSPI controller. This controller is
>> present in the Altera SoCFPGA SoCs and this driver has been tested
>> on the Cyclone V SoC.
>>

[...]

>> diff --git a/drivers/mtd/spi-nor/Kconfig b/drivers/mtd/spi-nor/Kconfig
>> index 43bafde..7e29050 100644
>> --- a/drivers/mtd/spi-nor/Kconfig
>> +++ b/drivers/mtd/spi-nor/Kconfig
>> @@ -50,4 +50,15 @@ config SPI_NXP_SPIFI
>>  	  Flash. Enable this option if you have a device with a SPIFI
>>  	  controller and want to access the Flash as a mtd device.
>>  
>> +config SPI_CADENCE_QUADSPI
>> +	tristate "Cadence Quad SPI controller"
>> +	depends on OF && (ARCH_SOCFPGA || COMPILE_TEST)
> 
> I think you can remove the ARCH_SOCFPGA dependency as this driver is
> used on a TI EVM as well.

I think above usage is correct. This will enable SPI_CADENCE_QUADSPI to
be selected when ARCH_SOCFPGA=y without having to enable COMPILE_TEST.
AFAIK, COMPILE_TEST is used usually to build test the driver w/o having
to enable ARCH specific configs (usually by maintainers).
For TI EVM, I would patch this file to add my architecture later(i.e
along with DT patch to my board).

-- 
Regards
Vignesh