[PATCH V8 1/2] mtd: spi-nor: Bindings for Cadence Quad SPI Flash Controller driver.

[Graham Moore]

On 02/08/2016 09:27 AM, Marek Vasut wrote:
> On Monday, February 08, 2016 at 12:19:25 PM, Vignesh R wrote:
>> On 02/06/2016 01:12 PM, Marek Vasut wrote:
>>> On Thursday, February 04, 2016 at 06:30:27 PM, R, Vignesh wrote:
>>>> On 2/4/2016 4:55 PM, Marek Vasut wrote:
>> [...]
>>
>>>> Yeah, there is delay(of few ns) required between writing to
>>>> INDIRECTWR_START bit and actually writing data to flash(i.e writesl()
>>>> call). This is specific to TI K2G SoC and needs to be tied to the new
>>>> binding.
>>>
>>> Can't you somehow poll the hardware to check whether or not it's ready
>>> instead of adding some random delay ?
>>
>> There is no dedicated register to poll as such.
>>
>> According to TRM:
>> "Wait for couple of cycles of QSPI_REF_CLK(functional clock of QSPI
>> @384MHz) until CQSPI_REG_INDIRECTWR[0] bit is internally synchronized by
>> the QSPI module before writing to flash".
>>
>> So, a few ns(~6ns @384MHz) delay is needed (or accessing a QSPI module
>> register should be sufficient as it will take more than 2 clock cycles).
>> I believe this delay is specific to TI K2G SoC and maybe needs to be
>> tied to the binding.
>
> OK, got it. Dinh/Graham, can you check if this might be needed on SoCFPGA too
> please?
>

I don't see any such requirement in the data sheet.  It's working 
without it.  So I think it's not needed on SoCFPGA

-Graham