[PATCH] mtd/nand: don't use {read,write}_buf for 8-bit transfers

[Uwe Kleine-König]

Hello,

On Thu, Feb 28, 2013 at 10:47:43AM +0800, Huang Shijie wrote:
> 于 2013年02月27日 23:10, Uwe Kleine-König 写道:
> >According to the Open NAND Flash Interface Specification (ONFI) Revision
> >3.1 "Parameters are always transferred on the lower 8-bits of the data
> >bus." for the Get Features and Set Features commands.
> >
> yes. the set/get features should works in 8-bit.
> 
> I have never met a 16-bit onfi nand yet. :)
> 
> >So using read_buf and write_buf is wrong for 16-bit wide nand chips as
> >they use I/O[15:0]. The Get Features command is easily fixed using 4
> >times the read_byte callback. For Set Features error out as there is no
> yes. for get features, it's easy to fix it.
> >write_byte callback.
> Most of the time, the nand controller will overwrite the write_buf hook...
> I also think we need a write_byte callback.
Is this an Ack for my patch?

Best regards
Uwe

-- 
Pengutronix e.K.                           | Uwe Kleine-König            |
Industrial Linux Solutions                 | http://www.pengutronix.de/  |