[PATCHv2 05/10] spi/qspi: Add api for get_buf/put_buf.

[Sourav Poddar]

On Tuesday 10 December 2013 06:28 PM, Marek Vasut wrote:
> On Friday, December 06, 2013 at 03:24:46 PM, Sourav Poddar wrote:
>> Adapt qspi driver to use (get_buf/put_buf) pointers added
>> earlier.
>> These can be called just before the memcpy operations to get hold
>> of the memory mapped address and to turn on the controller clocks.
>>
>> Signed-off-by: Sourav Poddar<sourav.poddar at ti.com>
>> ---
>> v1->v2:
>>   enable/disable memory mapped only when get_buf/put_buf is
>>   called (basicaaly only when memory mapped read operation is
>>   desired).
>>   drivers/spi/spi-ti-qspi.c |   19 +++++++++++++++++++
>>   1 files changed, 19 insertions(+), 0 deletions(-)
>>
>> diff --git a/drivers/spi/spi-ti-qspi.c b/drivers/spi/spi-ti-qspi.c
>> index e4a8afc..b83583c 100644
>> --- a/drivers/spi/spi-ti-qspi.c
>> +++ b/drivers/spi/spi-ti-qspi.c
>> @@ -248,6 +248,23 @@ static void ti_qspi_configure_from_slave(struct
>> spi_device *spi) ti_qspi_write(qspi, memval, QSPI_SPI_SETUP0_REG);
>>   }
>>
>> +static inline int  __iomem *ti_qspi_get_mem_buf(struct spi_master *master)
> Should this not be a 'void __iomem *' instead of 'int __iomem *' in any case ?
>
Yes, it should be. Will fix in v3.
>> +{
>> +	struct ti_qspi *qspi = spi_master_get_devdata(master);
>> +
>> +	pm_runtime_get_sync(qspi->dev);
>> +	enable_qspi_memory_mapped(qspi);
>> +	return qspi->mmap_base;
>> +}
>> +
>> +static void ti_qspi_put_mem_buf(struct spi_master *master)
>> +{
>> +	struct ti_qspi *qspi = spi_master_get_devdata(master);
>> +
>> +	disable_qspi_memory_mapped(qspi);
>> +	pm_runtime_put(qspi->dev);
>> +}
>> +
>>   static void ti_qspi_restore_ctx(struct ti_qspi *qspi)
>>   {
>>   	struct ti_qspi_regs *ctx_reg =&qspi->ctx_reg;
>> @@ -517,6 +534,8 @@ static int ti_qspi_probe(struct platform_device *pdev)
>>   	master->bits_per_word_mask = BIT(32 - 1) | BIT(16 - 1) | BIT(8 - 1);
>>   	master->mmap = true;
>>   	master->configure_from_slave = ti_qspi_configure_from_slave;
>> +	master->get_buf = ti_qspi_get_mem_buf;
>> +	master->put_buf = ti_qspi_put_mem_buf;
>>
>>   	if (!of_property_read_u32(np, "num-cs",&num_cs))
>>   		master->num_chipselect = num_cs;
> Best regards,
> Marek Vasut