[PATCHv2 05/10] spi/qspi: Add api for get_buf/put_buf.

[Marek Vasut]

On Friday, December 06, 2013 at 03:24:46 PM, Sourav Poddar wrote:
> Adapt qspi driver to use (get_buf/put_buf) pointers added
> earlier.
> These can be called just before the memcpy operations to get hold
> of the memory mapped address and to turn on the controller clocks.
> 
> Signed-off-by: Sourav Poddar <sourav.poddar at ti.com>
> ---
> v1->v2:
>  enable/disable memory mapped only when get_buf/put_buf is
>  called (basicaaly only when memory mapped read operation is
>  desired).
>  drivers/spi/spi-ti-qspi.c |   19 +++++++++++++++++++
>  1 files changed, 19 insertions(+), 0 deletions(-)
> 
> diff --git a/drivers/spi/spi-ti-qspi.c b/drivers/spi/spi-ti-qspi.c
> index e4a8afc..b83583c 100644
> --- a/drivers/spi/spi-ti-qspi.c
> +++ b/drivers/spi/spi-ti-qspi.c
> @@ -248,6 +248,23 @@ static void ti_qspi_configure_from_slave(struct
> spi_device *spi) ti_qspi_write(qspi, memval, QSPI_SPI_SETUP0_REG);
>  }
> 
> +static inline int  __iomem *ti_qspi_get_mem_buf(struct spi_master *master)

Should this not be a 'void __iomem *' instead of 'int __iomem *' in any case ?

> +{
> +	struct ti_qspi *qspi = spi_master_get_devdata(master);
> +
> +	pm_runtime_get_sync(qspi->dev);
> +	enable_qspi_memory_mapped(qspi);
> +	return qspi->mmap_base;
> +}
> +
> +static void ti_qspi_put_mem_buf(struct spi_master *master)
> +{
> +	struct ti_qspi *qspi = spi_master_get_devdata(master);
> +
> +	disable_qspi_memory_mapped(qspi);
> +	pm_runtime_put(qspi->dev);
> +}
> +
>  static void ti_qspi_restore_ctx(struct ti_qspi *qspi)
>  {
>  	struct ti_qspi_regs *ctx_reg = &qspi->ctx_reg;
> @@ -517,6 +534,8 @@ static int ti_qspi_probe(struct platform_device *pdev)
>  	master->bits_per_word_mask = BIT(32 - 1) | BIT(16 - 1) | BIT(8 - 1);
>  	master->mmap = true;
>  	master->configure_from_slave = ti_qspi_configure_from_slave;
> +	master->get_buf = ti_qspi_get_mem_buf;
> +	master->put_buf = ti_qspi_put_mem_buf;
> 
>  	if (!of_property_read_u32(np, "num-cs", &num_cs))
>  		master->num_chipselect = num_cs;

Best regards,
Marek Vasut