Intel Flash
Vipin Malik
vipin.malik at daniel.com
Wed Apr 18 14:57:16 EDT 2001
Marcio Koch wrote:
> TE28F320
^^^^^^^^^^^^^ This is the part #. You can ignore the rest of the stuff.
Go to www.intel.com and download the datasheet on this part and see if it is a
CFI compatable NOR flash or not.
If not CFI, but is NOR, then try to use the JDEC module, rather than the CFI
module. If Not NOR (i.e. if NAND)
then I don't know.
Hope this helps.
Vipin
P.S. This is really a MTD issue and you will probably have more luck posting
to that list. I've CC to that list if you
need the email.
>
> B3BA110
> U9490626A
> (c)1998
>
> Does anybody know if this flash is supported by linux ? If so what kernel
> and mtd code should I use ?
>
> For MPC8xx.
>
> I'm using kernel 2.4.3-pre4 and it fails when I try to load the physmap
> module.
>
> Here is what I did and the error I got:
>
> sh-2.03# modprobe -a mtdchar mtdblock cfi_cmdset_0001 map_rom cfi_probe
> sh-2.03# lsmod
> Module Size Used by
> cfi_probe 7920 0 (unused)
> map_rom 1072 0 (unused)
> cfi_cmdset_0001 8000 0 (unused)
> mtdblock 6528 0 (unused)
> mtdchar 5408 0 (unused)
> mtdcore 2976 2 [mtdblock mtdchar]
> sh-2.03# modprobe -a physmap
> physmap flash device: 3fffff at fe000000
> Physically mapped flash: Found no CFI device at location zero
> /lib/modules/2.4.3-pre4/kernel/drivers/mtd/physmap.o: init_module: Device
> not configured
> Hint: insmod errors can be caused by incorrect module parameters, including
> invalid IO or IRQ parameters
> /lib/modules/2.4.3-pre4/kernel/drivers/mtd/physmap.o: insmod
> /lib/modules/2.4.3-pre4/kernel/drivers/mtd/physmap.o failed
> /lib/modules/2.4.3-pre4/kernel/drivers/mtd/physmap.o: insmod physmap failed
>
> Any help would be appreciated.
>
> Thanks,
>
> Marcio Koch
> koch at inf.pucrs.br
> PUCRS/ELinux
>
> To unsubscribe from this list: send the line "unsubscribe jffs-dev" in
> the body of a message to majordomo at axis.com
To unsubscribe, send "unsubscribe mtd" to majordomo at infradead.org
More information about the linux-mtd
mailing list