[PATCH v2 8/8] PCI: rzg3s-host: Add 100 ms delay after link training

[Claudiu Beznea]

Hi, Hans,

On 5/6/26 18:23, Hans Zhang wrote:
> The Renesas RZ/G3S PCIe host driver currently does not enforce the
> mandatory 100 ms delay after link training completes for speeds > 5.0 GT/s,
> required by PCIe r6.0 sec 6.6.1.
> 
> The driver already has a 'max_link_speed' field (derived from the device
> tree). Add a call to pcie_wait_after_link_train() in
> rzg3s_pcie_host_init() after reading the link status, ensuring that the
> delay is applied before any Configuration Request is sent downstream.
> 
> Signed-off-by: Hans Zhang <18255117159 at 163.com>
> ---
>   drivers/pci/controller/pcie-rzg3s-host.c | 2 ++
>   1 file changed, 2 insertions(+)
> 
> diff --git a/drivers/pci/controller/pcie-rzg3s-host.c b/drivers/pci/controller/pcie-rzg3s-host.c
> index d86e7516dcc2..6ab59c5464cf 100644
> --- a/drivers/pci/controller/pcie-rzg3s-host.c
> +++ b/drivers/pci/controller/pcie-rzg3s-host.c
> @@ -1390,6 +1390,8 @@ static int rzg3s_pcie_host_init(struct rzg3s_pcie_host *host)
>   	val = readl_relaxed(host->axi + RZG3S_PCI_PCSTAT2);
>   	dev_info(host->dev, "PCIe link status [0x%x]\n", val);
>   
> +	pcie_wait_after_link_train(host->max_link_speed);

There is an msleep(PCIE_RESET_CONFIG_WAIT_MS) after 
rzg3s_pcie_set_max_link_speed() call. Shouldn't that msleep() call be replaced 
with your pcie_wait_after_link_train() ?

Thank you,
Claudiu