[PATCH v4 1/3] spi: airoha-snfi: en7523: workaround flash damaging if UART_TXD was short to GND

[Mikhail Kshevetskiy]

On 11/25/25 10:18, Andy Shevchenko wrote:
> On Tue, Nov 25, 2025 at 05:10:49AM +0300, Mikhail Kshevetskiy wrote:
>> Airoha EN7523 specific bug
>> --------------------------
>> We found that some serial console may pull TX line to GROUND during board
>> boot time. Airoha uses TX line as one of it's BOOT pins.
> I know the term bootstrap, what does BOOT mean?

yes, it's bootstrap pin

>
>> On the EN7523 SoC this may lead to booting in RESERVED boot mode.
>>
>> It was found that some flashes operates incorrectly in RESERVED mode.
>> Micron and Skyhigh flashes are definitely affected by the issue,
>> Winbond flashes are NOT affected.
> NOT --> not
will fix
>
>> Details:
>> --------
>> DMA reading of odd pages on affected flashes operates incorrectly. Page
>> reading offset (start of the page) on hardware level is replaced by 0x10.
>> Thus results in incorrect data reading. As result OS loading becomes
>> impossible.
>>
>> Usage of UBI make things even worse. On attaching, UBI will detects
>> corruptions (because of wrong reading of odd pages) and will try to
>> recover. For recovering UBI will erase and write 'damaged' blocks with
>> a valid information. This will destroy all UBI data.
>>
>> Non-DMA reading is OK.
>>
>> This patch detects booting in reserved mode, turn off DMA and print big
>> fat warning.
> ...
>
>> -	err = dma_set_mask(as_ctrl->dev, DMA_BIT_MASK(32));
>> -	if (err)
>> -		return err;
>> +	if (dma_enable) {
>> +		err = dma_set_mask(as_ctrl->dev, DMA_BIT_MASK(32));
>> +		if (err)
>> +			return err;
>> +	}
> Why do you need this to be conditional? The settings of DMA mask should not
> affect the (in)ability of the device to perform DMA. I.o.w. it should not
> influence PIO mode. Can you confirm this?
>
no any particular reason, just see no sense to set mask if dma will not
be used


Regards,

Mikhail Kshevetskiy