[PATCH 2/2] dt-bindings: mmc: mtk-sd: Add support for MT8196

[Andy-ld Lu (卢东)]

On Thu, 2024-09-26 at 12:54 -0500, Rob Herring wrote:
>  	 
> External email : Please do not click links or open attachments until
> you have verified the sender or the content.
>  On Thu, Sep 26, 2024 at 03:03:18PM +0800, Andy-ld Lu wrote:
> > Extend the devicetree bindings to include the MT8196 mmc controller
> > by adding the compatible string 'mediatek,msdc-v2', which could be
> > also used for future compatible SoCs that support new tx/rx.
> 
> Generally, every SoC ends up changing at least slightly. So we don't
> do 
> version numbers except when there's a well defined versioning scheme
> of 
> the h/w (e.g. FPGA IP blocks). So, use SoC for compatible string.
Thanks for your review.

The new tx/rx represents a significant update for mmc controller of
mediatek from the MT8196 chipset, and the dependent settings remain
consistent for MT8196 and subsequent SoCs. Therefore, It is proposed to
use a unified compatible string for these SoCs that support new tx/rx,
and name it as 'IP(msdc) version two'.
> 
> > 
> > Add three properties for MT8196 settings:
> > - 'mediatek,prohibit-gate-cg', indicate if the source clock CG
> could
> >   be disabled when CPU access IP registers.
> > 
> > - 'mediatek,stop-dly-sel', configure read data clock stops at block
> gap.
> > 
> > - 'mediatek,pop-en-cnt', configure the margins of write and read
> >   pointers while begin to pop data transfer.
> > 
> > Signed-off-by: Andy-ld Lu <andy-ld.lu at mediatek.com>
> > ---
> >  .../devicetree/bindings/mmc/mtk-sd.yaml       | 26
> +++++++++++++++++++
> >  1 file changed, 26 insertions(+)
> > 
> > diff --git a/Documentation/devicetree/bindings/mmc/mtk-sd.yaml
> b/Documentation/devicetree/bindings/mmc/mtk-sd.yaml
> > index c532ec92d2d9..82d1a9fac67c 100644
> > --- a/Documentation/devicetree/bindings/mmc/mtk-sd.yaml
> > +++ b/Documentation/devicetree/bindings/mmc/mtk-sd.yaml
> > @@ -25,6 +25,7 @@ properties:
> >            - mediatek,mt8173-mmc
> >            - mediatek,mt8183-mmc
> >            - mediatek,mt8516-mmc
> > +          - mediatek,msdc-v2
> >        - items:
> >            - const: mediatek,mt7623-mmc
> >            - const: mediatek,mt2701-mmc
> > @@ -154,6 +155,30 @@ properties:
> >      enum: [32, 64]
> >      default: 32
> >  
> > +  mediatek,stop-dly-sel:
> > +    $ref: /schemas/types.yaml#/definitions/uint32
> > +    description:
> > +      Some SoCs need to set appropriate stop-dly-sel to configure
> read data clock
> > +      stops at block gap. The valid range is from 0 to 0xf.
> 
> SoC dependent or board dependent? Imply from the compatible for the 
> former. A property is fine for the latter case.
Yes, it is SoC dependent in principle, but we would like to use a
unified compatible string for MT8196 and subsequent SoCs as mentioned
above, and this register setting(not relavant with new tx/rx) may be
variant. Therefore, want to use the property of device tree to set
individually.
> 
> > +    minimum: 0
> > +    maximum: 0xf
> > +
> > +  mediatek,pop-en-cnt:
> > +    $ref: /schemas/types.yaml#/definitions/uint32
> > +    description:
> > +      Some SoCs need to set appropriate pop-en-cnt to configure
> the margins of write
> > +      and read pointers while begin to pop data transfer. The
> valid range is from 0
> > +      to 0xf.
> > +    minimum: 0
> > +    maximum: 0xf
> 
> Same question.
Same as the reply above.
> 
> > +
> > +  mediatek,prohibit-gate-cg:
> > +    $ref: /schemas/types.yaml#/definitions/flag
> > +    description:
> > +      Decide if source clock CG could be disabled when CPU access
> IP registers.
> > +      If present, source clock CG could not be disabled.
> > +      If not present, source clock CG could be disabled.
> 
> 
> Sounds like you need to describe the clock in "clocks".
It is not with clock itself, but rather with the bus design that would
check the 'source_cg' status bit to decide whether to prevent the CPU
from accessing the IP registers. And there have been no changes to the
'source_cg'(already been descirbed before) for MT8196.
> 
> > +
> >    resets:
> >      maxItems: 1
> >  
> > @@ -191,6 +216,7 @@ allOf:
> >              - mediatek,mt8188-mmc
> >              - mediatek,mt8195-mmc
> >              - mediatek,mt8516-mmc
> > +            - mediatek,msdc-v2
> >      then:
> >        properties:
> >          clocks:
> > -- 
> > 2.46.0
> >