[PATCH v2 3/3] mips: dts: ralink: mt7621: add serial1 and serial2 nodes

[Arınç ÜNAL]

On 8.03.2024 11:44, AngeloGioacchino Del Regno wrote:
> Il 07/03/24 20:04, Justin Swartz ha scritto:
>> Add serial1 and serial2 nodes to define the existence of
>> the MT7621's second and third UARTs.
>>
>> Signed-off-by: Justin Swartz <justin.swartz at risingedge.co.za>
>> ---
>>   arch/mips/boot/dts/ralink/mt7621.dtsi | 28 +++++++++++++++++++++++++++
>>   1 file changed, 28 insertions(+)
>>
>> diff --git a/arch/mips/boot/dts/ralink/mt7621.dtsi b/arch/mips/boot/dts/ralink/mt7621.dtsi
>> index 3ad4e2343..5a89f0b8c 100644
>> --- a/arch/mips/boot/dts/ralink/mt7621.dtsi
>> +++ b/arch/mips/boot/dts/ralink/mt7621.dtsi
>> @@ -124,6 +124,34 @@ serial0: serial at c00 {
>>               pinctrl-0 = <&uart1_pins>;
>>           };
>> +        serial1: serial at d00 {
>> +            compatible = "ns16550a";
>> +            reg = <0xd00 0x100>;
>> +            reg-io-width = <4>;
>> +            reg-shift = <2>;
>> +            clocks = <&sysc MT7621_CLK_UART2>;
>> +            interrupt-parent = <&gic>;
>> +            interrupts = <GIC_SHARED 27 IRQ_TYPE_LEVEL_HIGH>;
>> +            no-loopback-test;
>> +            pinctrl-names = "default";
>> +            pinctrl-0 = <&uart2_pins>;
> 
> As already commented on patch [1/3], pin muxing is board specific. Please remove.
> 
> Also, is there any reason why you can't simply use the `interrupts-extended`
> property instead of interrupt-parent and interrupts?

I'm looking at the documentation [1], it seems to be useful when multiple
interrupt parents need to be defined on a node. I'd continue using
interrupt-parent and interrupts in this case.

[1] https://www.kernel.org/doc/Documentation/devicetree/bindings/interrupt-controller/interrupts.txt

Arınç