[PATCH 7/8] arm64: dts: qcom: ipq5018: enable ethernet support

[Ziyang Huang]

Signed-off-by: Ziyang Huang <hzyitc at outlook.com>
---
 arch/arm64/boot/dts/qcom/ipq5018.dtsi | 120 +++++++++++++++++++++++++-
 1 file changed, 116 insertions(+), 4 deletions(-)

diff --git a/arch/arm64/boot/dts/qcom/ipq5018.dtsi b/arch/arm64/boot/dts/qcom/ipq5018.dtsi
index e502a3ecf4b7..b36e5c2136b7 100644
--- a/arch/arm64/boot/dts/qcom/ipq5018.dtsi
+++ b/arch/arm64/boot/dts/qcom/ipq5018.dtsi
@@ -94,6 +94,63 @@ soc: soc at 0 {
 		#size-cells = <1>;
 		ranges = <0 0 0 0xffffffff>;
 
+		mdio0: mdio at 88000 {
+			#address-cells = <1>;
+			#size-cells = <0>;
+			compatible = "qcom,ipq5018-mdio", "qcom,qca-mdio";
+			reg = <0x88000 0x64>;
+			resets = <&gcc GCC_GEPHY_MDC_SW_ARES>,
+				 <&gcc GCC_GEPHY_DSP_HW_ARES>;
+			clocks = <&gcc GCC_MDIO0_AHB_CLK>;
+			clock-names = "gcc_mdio_ahb_clk";
+			status = "disabled";
+
+			gephy: ethernet-phy at 7 {
+				#clock-cells = <1>;
+				reg = <7>;
+				resets = <&gcc GCC_GEPHY_BCR>,
+					 <&gcc GCC_GEPHY_RX_ARES>,
+					 <&gcc GCC_GEPHY_TX_ARES>;
+				clocks = <&gcc GCC_GEPHY_RX_CLK>,
+					 <&gcc GCC_GEPHY_TX_CLK>;
+			};
+		};
+
+		mdio1: mdio at 90000 {
+			#address-cells = <1>;
+			#size-cells = <0>;
+			compatible = "qcom,ipq5018-mdio";
+			reg = <0x90000 0x64>;
+			clocks = <&gcc GCC_MDIO1_AHB_CLK>;
+			clock-names = "gcc_mdio_ahb_clk";
+			status = "disabled";
+		};
+
+		uniphy0: eth-uniphy at 98000 {
+			compatible = "qcom,ipq5018-eth-uniphy";
+			#clock-cells = <1>;
+			#phy-cells = <0>;
+			reg = <0x98000 0x800>,
+			      <0x9b000 0x800>,
+			      <0x19475c4 0x4>;
+			reg-names = "uniphy",
+				    "cmn",
+				    "tcsr";
+			clocks = <&gcc GCC_CMN_BLK_AHB_CLK>,
+				 <&gcc GCC_CMN_BLK_SYS_CLK>,
+				 <&gcc GCC_UNIPHY_AHB_CLK>,
+				 <&gcc GCC_UNIPHY_SYS_CLK>,
+				 <&gcc GCC_UNIPHY_RX_CLK>,
+				 <&gcc GCC_UNIPHY_TX_CLK>;
+			resets = <&gcc GCC_UNIPHY_BCR>,
+				 <&gcc GCC_UNIPHY_AHB_ARES>,
+				 <&gcc GCC_UNIPHY_SYS_ARES>,
+				 <&gcc GCC_UNIPHY_RX_ARES>,
+				 <&gcc GCC_UNIPHY_TX_ARES>;
+
+			status = "disabled";
+		};
+
 		tlmm: pinctrl at 1000000 {
 			compatible = "qcom,ipq5018-tlmm";
 			reg = <0x01000000 0x300000>;
@@ -120,10 +177,10 @@ gcc: clock-controller at 1800000 {
 				 <0>,
 				 <0>,
 				 <0>,
-				 <0>,
-				 <0>,
-				 <0>,
-				 <0>;
+				 <&gephy 0>,
+				 <&gephy 1>,
+				 <&uniphy0 0>,
+				 <&uniphy0 1>;
 			#clock-cells = <1>;
 			#reset-cells = <1>;
 			#power-domain-cells = <1>;
@@ -244,6 +301,61 @@ frame at b128000 {
 				status = "disabled";
 			};
 		};
+
+		gmac0: ethernet at 39c00000 {
+			compatible = "qcom,ipq50xx-gmac", "snps,dwmac";
+			reg = <0x39C00000 0x10000>;
+			clocks = <&gcc GCC_GMAC0_SYS_CLK>,
+				 <&gcc GCC_GMAC0_CFG_CLK>,
+				 <&gcc GCC_SNOC_GMAC0_AHB_CLK>,
+				 <&gcc GCC_SNOC_GMAC0_AXI_CLK>,
+				 <&gcc GCC_GMAC0_RX_CLK>,
+				 <&gcc GCC_GMAC0_TX_CLK>,
+				 <&gcc GCC_GMAC0_PTP_CLK>;
+			clock-names = "sys",
+				      "cfg",
+				      "ahb",
+				      "axi",
+				      "rx",
+				      "tx",
+				      "ptp";
+			resets = <&gcc GCC_GMAC0_BCR>;
+			interrupts = <GIC_SPI 101 IRQ_TYPE_LEVEL_HIGH>;
+			interrupt-names = "macirq";
+
+			phy-handle = <&gephy>;
+			phy-mode = "sgmii";
+
+			status = "disabled";
+		};
+
+		gmac1: ethernet at 39d00000 {
+			compatible = "qcom,ipq50xx-gmac", "snps,dwmac";
+			reg = <0x39D00000 0x10000>;
+			reg-names = "stmmaceth";
+			clocks = <&gcc GCC_GMAC1_SYS_CLK>,
+				 <&gcc GCC_GMAC1_CFG_CLK>,
+				 <&gcc GCC_SNOC_GMAC1_AHB_CLK>,
+				 <&gcc GCC_SNOC_GMAC1_AXI_CLK>,
+				 <&gcc GCC_GMAC1_RX_CLK>,
+				 <&gcc GCC_GMAC1_TX_CLK>,
+				 <&gcc GCC_GMAC1_PTP_CLK>;
+			clock-names = "sys",
+				      "cfg",
+				      "ahb",
+				      "axi",
+				      "rx",
+				      "tx",
+				      "ptp";
+			resets = <&gcc GCC_GMAC1_BCR>;
+			interrupts = <GIC_SPI 109 IRQ_TYPE_LEVEL_HIGH>;
+			interrupt-names = "macirq";
+
+			phys = <&uniphy0>;
+			phy-names = "uniphy";
+
+			status = "disabled";
+		};
 	};
 
 	timer {
-- 
2.40.1