Aw: Re: [PATCH v3 0/5] arm: dts: mt7623: relocate gmacs, mt7530 switch, and add port at 5

[Arınç ÜNAL]

On 18.02.2023 13:24, Frank Wunderlich wrote:
> Hi,
> 
> finally get some time to bootup with this series on my r2.
> 
> I see that inserting the port at 5 as cpu-port maps this as default-cpu because dsa-core uses first found cpu-port as
> default (dsa_tree_setup_cpu_ports in dsa.c) and because of lower bandwidth (rgmii instead of trgmii) not the best choice.
> 
> But it look worse...network is currently broken (set both gmacs up).
> I see arp-packets reaching remote side, but reponse is not received by r2
> 
> I have tested it on 6.2-rc8 (wan-port), maybe additional patches are needed?...userspace setup should be right.
> 
> so i added series on top of net-next (no additional patches except some basic like build-script,defconfig and such)...same result...
> 
> i'm not sure if i change the mapping from userspace back to eth0, so disabled port at 5 in switch, now port6 is
> cpu-port again and it works...so something is wrong with port5 of switch or gmac1.

That's a driver issue and will be fixed once an accepted version of 
these patches [0] [1] [2] are applied to net-next. You should have them 
on your inbox, I specifically told Richard to CC you.

This is devicetree bindings. We're here to describe the hardware. The 
way a driver works should not affect describing the hardware.

To address the lower bandwidth situation you mentioned, a devicetree 
property to designate a CPU port as the default CPU port could be 
introduced. I'm not aware of a similar conversation so I'll send a mail 
to netdev to discuss this. Will CC you.

[0] 
https://lore.kernel.org/netdev/20230212213949.672443-1-richard@routerhints.com/
[1] 
https://lore.kernel.org/netdev/20230212214027.672501-1-richard@routerhints.com/
[2] 
https://lore.kernel.org/netdev/20230212215152.673221-1-richard@routerhints.com/

Arınç