[PATCH v2 1/5] pinctrl: mediatek: add generic driving setup property on mt8192

Nícolas F. R. A. Prado nfraprado at collabora.com
Fri Jun 24 08:52:24 PDT 2022


Hi Guodong,

please see comments below.

On Fri, Jun 24, 2022 at 09:36:56PM +0800, Guodong Liu wrote:
> 1. The dt-binding expects that drive-strength arguments be passed
> in mA, but the driver was expecting raw values. And that this
> commit changes the driver so that it is aligned with the binding.
> 2. This commit provides generic driving setup, which support
> 2/4/6/8/10/12/14/16mA driving, original driver just set raw data
> setup setting when use drive-strength property.

This commit message is a bit confusing, I suggest using the following commit
message instead:

The dt-binding expects the drive-strength arguments to be passed in mA, but the
driver was using callbacks that expect raw values instead. Change the callbacks
for the ones that operate on mA values, so that the driver is in accordance to
the dt-binding.

The drive-strength property requiring values in mA is the standard and other
MediaTek SoCs of the same generation already do the same, so this change avoids
mt8192 having a non-standard property.

There are no current upstream users of this driver, so this change doesn't cause
any regression.

> 
> Signed-off-by: Guodong Liu <guodong.liu at mediatek.com>

Reviewed-by: Nícolas F. R. A. Prado <nfraprado at collabora.com>
Tested-by: Nícolas F. R. A. Prado <nfraprado at collabora.com>

Thanks,
Nícolas



More information about the Linux-mediatek mailing list