[RESEND PATCH v4] arm64: dts: mt8195: Add Ethernet controller

[Andrew Lunn]

> +&eth {
> +	phy-mode ="rgmii-rxid";

That is pretty unusual. You don't see rxid, or txid very often, it is
normally rgmii, or rgmii-id.

> +	phy-handle = <&ethernet_phy0>;
> +	snps,reset-gpio = <&pio 93 GPIO_ACTIVE_HIGH>;
> +	snps,reset-delays-us = <0 10000 10000>;
> +	mediatek,tx-delay-ps = <2030>;

How important is the 30 here?

You appear to have the PHY doing the RX delay, and the MAC doing the
TX delay. Normally we have the PHY do both. Can you actually do

phy-mode = "rgmii-id", and mediatek,tx-delay-ps = <30> ? That would
then have the PHY doing the basic 2ns delay, and the MAC doing the
fine tuning needed for TX?

     Andrew