[PATCH v9 1/3] dt-bindings: mmc: mtk-sd: extend interrupts and pinctrls properties

[Ulf Hansson]

On Fri, 1 Apr 2022 at 11:22, Ulf Hansson <ulf.hansson at linaro.org> wrote:
>
> On Tue, 29 Mar 2022 at 05:29, Axe Yang <axe.yang at mediatek.com> wrote:
> >
> > Extend interrupts and pinctrls for SDIO wakeup interrupt feature.
> > This feature allow SDIO devices alarm asynchronous interrupt to host
> > even when host stop providing clock to SDIO card. An extra wakeup
> > interrupt and pinctrl states for SDIO DAT1 pin state switching are
> > required in this scenario.
> >
> > Signed-off-by: Axe Yang <axe.yang at mediatek.com>
> > ---
> >  .../devicetree/bindings/mmc/mtk-sd.yaml         | 17 ++++++++++++++++-
> >  1 file changed, 16 insertions(+), 1 deletion(-)
> >
> > diff --git a/Documentation/devicetree/bindings/mmc/mtk-sd.yaml b/Documentation/devicetree/bindings/mmc/mtk-sd.yaml
> > index 297ada03e3de..3872a6ce2867 100644
> > --- a/Documentation/devicetree/bindings/mmc/mtk-sd.yaml
> > +++ b/Documentation/devicetree/bindings/mmc/mtk-sd.yaml
> > @@ -69,12 +69,22 @@ properties:
> >        - const: ahb_cg
> >
> >    interrupts:
> > -    maxItems: 1
> > +    description:
> > +      Should at least contain MSDC GIC interrupt. To support SDIO in-band wakeup, an extended
> > +      interrupt is required and be configured as wakeup source irq.
>
> If I understand correctly, the extended interrupt (a GPIO irq) may not
> necessarily share the same interrupt parent as the primary device
> interrupt.
>
> Perhaps it's then better to extend this with "interrupts-extended"
> instead. See Documentation/devicetree/bindings/interrupt-controller/interrupts.txt.

One more thing, looks like using the "interrupt-names" property would
be good to use too. To easier distinguish the different irqs.

[...]

Kind regards
Uffe