[PATCH v9 1/3] dt-bindings: mmc: mtk-sd: extend interrupts and pinctrls properties

Ulf Hansson ulf.hansson at linaro.org
Fri Apr 1 02:22:13 PDT 2022


On Tue, 29 Mar 2022 at 05:29, Axe Yang <axe.yang at mediatek.com> wrote:
>
> Extend interrupts and pinctrls for SDIO wakeup interrupt feature.
> This feature allow SDIO devices alarm asynchronous interrupt to host
> even when host stop providing clock to SDIO card. An extra wakeup
> interrupt and pinctrl states for SDIO DAT1 pin state switching are
> required in this scenario.
>
> Signed-off-by: Axe Yang <axe.yang at mediatek.com>
> ---
>  .../devicetree/bindings/mmc/mtk-sd.yaml         | 17 ++++++++++++++++-
>  1 file changed, 16 insertions(+), 1 deletion(-)
>
> diff --git a/Documentation/devicetree/bindings/mmc/mtk-sd.yaml b/Documentation/devicetree/bindings/mmc/mtk-sd.yaml
> index 297ada03e3de..3872a6ce2867 100644
> --- a/Documentation/devicetree/bindings/mmc/mtk-sd.yaml
> +++ b/Documentation/devicetree/bindings/mmc/mtk-sd.yaml
> @@ -69,12 +69,22 @@ properties:
>        - const: ahb_cg
>
>    interrupts:
> -    maxItems: 1
> +    description:
> +      Should at least contain MSDC GIC interrupt. To support SDIO in-band wakeup, an extended
> +      interrupt is required and be configured as wakeup source irq.

If I understand correctly, the extended interrupt (a GPIO irq) may not
necessarily share the same interrupt parent as the primary device
interrupt.

Perhaps it's then better to extend this with "interrupts-extended"
instead. See Documentation/devicetree/bindings/interrupt-controller/interrupts.txt.

> +    minItems: 1
> +    maxItems: 2
>
>    pinctrl-names:
> +    description:
> +      Should at least contain default and state_uhs. To support SDIO in-band wakeup, dat1 pin
> +      will be switched between GPIO mode and SDIO DAT1 mode, state_eint and state_dat1 are
> +      mandatory in this scenarios.
> +    minItems: 2
>      items:
>        - const: default
>        - const: state_uhs
> +      - const: state_eint
>
>    pinctrl-0:
>      description:
> @@ -86,6 +96,11 @@ properties:
>        should contain uhs mode pin ctrl.
>      maxItems: 1
>
> +  pinctrl-2:
> +    description:
> +      should switch dat1 pin to GPIO mode.
> +    maxItems: 1
> +
>    assigned-clocks:
>      description:
>        PLL of the source clock.
> --
> 2.25.1
>

Kind regards
Uffe



More information about the Linux-mediatek mailing list