gpio setting

[sneha prakash]

Hi doron,

  kernel version is 2.6.31.

Regards,
sneha

On Sun, May 30, 2010 at 6:10 PM, doron sandroy <doronsa at gmail.com> wrote:

> what is kernel version?
> regars .
> s.doron.
>
> 2010/5/14 sneha prakash <sneghu at gmail.com>
>
>>
>>
>> ---------- Forwarded message ----------
>> From: sneha prakash <sneghu at gmail.com>
>> Date: Thu, May 13, 2010 at 3:12 PM
>> Subject: arm gpio setting
>> To: linux-arm at lists.infradead.org
>>
>>
>> Hi ,
>>         We are using i.mx 25 board which consists of arm9 controller.I
>> need to
>>         convert the CMOS connector in the board to parallel port pins.We
>> have to
>>         convert CMOS connector pins to GPIO pins using IOMUX
>> configuration.Could
>>         any one help me to configure GPIO pins as parallel port pins and
>> to set
>>         the base address.
>> Regards,
>>       sneha.
>>
>>
>>
>> _______________________________________________
>> linux-arm mailing list
>>
>> linux-arm at lists.infradead.org
>> http://lists.infradead.org/mailman/listinfo/linux-arm
>>
>>
>
>
> --
> doron sandroy
> doronsa at gmail.com
> 052-6070406
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.infradead.org/pipermail/linux-arm/attachments/20100530/26ab075a/attachment-0001.html>