[PATCH net] net: lpc_eth: release the PHY device node reference

[Vladimir Zapolskiy]

On 10/22/26 18:59, Yige Jiang wrote:
> lpc_eth_drv_probe() obtains a reference to phy-handle and stores it in
> pldat->phy_node for lpc_mii_probe(). Neither PHY lookup nor connecting
> the PHY consumes that node reference. The probe error paths and driver
> removal discard the stored pointer without releasing the reference.
> 
> Put the node at err_out_dma_unmap, which is reached by both failure
> paths after the phandle lookup, and on remove after unregistering the
> network device and MII bus. Both puts run before free_netdev(), since
> pldat is stored in the netdev private area. Earlier probe failures do
> not pass the new error-path put.
> 
> The PHY device reference discussed in the linked review is a different
> reference. This patch only fixes the node reference, which was also
> mentioned in that discussion; it does not repeat the proposed PHY
> device cleanup.
> 
> LLM assistance was used for static ownership analysis and drafting of
> this change and its changelog. The review traced get/put pairs, error
> paths and teardown ordering. No runtime reproducer or hardware test
> is available.
> 
> Fixes: 3503bf024b3e ("net: lpc_eth: parse phy nodes from device tree")
> Link: https://patchwork.kernel.org/patch/14502432/
> Assisted-by: LLM
> Signed-off-by: Yige Jiang <yigejiang86 at gmail.com>

The change is correct, thank you for the fix!

Reviewed-by: Vladimir Zapolskiy <vz at kernel.org>

-- 
Best wishes,
Vladimir