[PATCH v7 0/2] Add initial support for Qualcomm Kuno SoC

[Hardeep Sharma]

On 9/29/2026 3:18 PM, Hardeep Sharma wrote:
> This series adds initial support for the Qualcomm Kuno SoC and the Kuno
> IDP reference board.
>
> Kuno is a 32-bit ARM (Cortex-A7) Qualcomm platform. The rest of the
> series (bindings, GCC, RPMh clocks and power domains, interconnect,
> pinctrl, geni-se) has been applied and is in linux-next, so v7 carries
> only the SoC and IDP board devicetree, plus a small geni-se binding
> update that lets the QUP wrapper use one address/size cell on 32-bit
> SoCs.
>
> Signed-off-by: Hardeep Sharma <hardeep.sharma at oss.qualcomm.com>
> ---
> Changes in v7:
> - Addressed v6 review feedback:
>    - New patch: allow 1 or 2 #address-cells/#size-cells in the geni-se
>      QUP wrapper binding.
>    - Switched the QUP wrapper to one address/size cell with an empty
>      ranges, instead of the explicit 32-bit window.
> - Link to v6: https://lore.kernel.org/all/20260929-kuno-soc-support-v6-1-a16afafbcbc7@oss.qualcomm.com/
>
> Changes in v6:
> - Rebased on next-20260928. The rest of the series has been applied,
>    so only the devicetree patch remains.
> - Addressed v5 review feedback:
>    - Added the full qcom,pdc-ranges map (22 ranges instead of 3), so
>      that all PDC-routed wakeup GPIOs can wake the system.
>    - Added wakeup-parent = <&pdc> to the TLMM node.
>    - Replaced the explicit soc ranges with an empty ranges and named the
>      node soc, matching the other 32-bit Qualcomm SoCs.
>    - Widened the QUP wrapper ranges to cover the whole 32-bit address
>      space instead of a 16 MiB window.
> - Link to v5: https://lore.kernel.org/all/20260827-kuno-soc-support-v5-0-6d47636a8f09@oss.qualcomm.com/
>
> Changes in v5:
> - Selected QCOM_GDSC from the Kuno GCC config. The driver registers GDSCs
>    (added in v4), so like the other Qualcomm GCC drivers it must select
>    QCOM_GDSC; otherwise, in a configuration where nothing else enables it
>    (e.g. COMPILE_TEST or a minimal Kuno-only build), gdsc_register() returns
>    -ENOSYS and the clock controller fails to probe.
> - Link to v4: https://lore.kernel.org/all/20260827-kuno-soc-support-v4-0-dd34f235fc1a@oss.qualcomm.com/
>
> Changes in v4:
> - Addressed v3 review feedback:
>    - Registered the interconnect NoC provider from an explicit
>      core_initcall() instead of module_platform_driver(), matching the
>      established qcom interconnect driver convention.
>    - Replaced the NA mux-slot placeholder with _ across the pinctrl
>      PINGROUP table, matching the upstream qcom pinctrl convention.
>    - Added minItems: 1 to the interconnect binding clocks property so a
>      single clock is valid (system-noc), and aligned the binding
>      examples with the sdx75 labelled-node style.
>    - Added GDSC power-domain support to the Kuno GCC: the binding now
>      defines GDSC macros and the driver registers the EMAC0, PCIe and
>      USB20 GDSCs, so #power-domain-cells has real backing providers.
>    - Split the cpu-idle-states phandle list so each phandle is on its
>      own line.
>    - Collected Acked-by / Reviewed-by tags from v3.
> - Link to v3: https://lore.kernel.org/all/20260821-kuno-soc-support-v3-0-196e2b306368@oss.qualcomm.com/
>
> Changes in v3:
> - Addressed v2 review feedback:
>    - Reworked the interconnect binding clocks: dropped clock-names and
>      replaced the flexible min/maxItems list with fixed per-compatible
>      clocks (aggre-noc: 2, system-noc: 1), required where present and
>      disallowed otherwise, matching the sdx75/glymur shape.
>    - Made #power-domain-cells required on the Kuno GCC binding and
>      declared it on the SoC gcc node, since the Kuno GCC hosts GDSCs and
>      is a power-domain provider (following qcom,sdx75-gcc); the driver's
>      GDSC support will follow separately.
>    - Made the GPIO65/66 QDSS CTI trig1 funcsel-3 route selectable: added
>      a distinct qdss_cti_trig1_mire pin function (and allowed it in the
>      TLMM binding enum), as the duplicate funcsel-2/3 entry left
>      funcsel-3 unreachable.
>    - Collected Acked-by / Reviewed-by tags from v2.
> - Link to v2: https://lore.kernel.org/all/20260814-kuno-soc-support-v2-0-3079794f0f73@oss.qualcomm.com/
>
> Changes in v2:
> - Addressed v1 review feedback:
>    - Reworked soc: qcom: geni-se commit message; dropped the Fixes: tag.
>    - Reworded dt-bindings commit messages to the "Document X for the
>      Qualcomm Kuno SoC" one-liner form.
>    - Canonicalized copyright headers on interconnect binding / driver /
>      NoC ID header to the single-line Qualcomm Technologies form.
>    - Dropped unused <linux/mod_devicetable.h> from the interconnect
>      driver.
>    - Fixed MODULE_DESCRIPTION casing "KUNO" -> "Kuno" in the interconnect
>      driver.
>    - Extended interconnect binding to optionally allow up to four QoS AHB
>      clocks (matches sdx75/glymur shape).
>    - Cleaned up brace/space style in gcc-kuno.c to match peer clock
>      drivers.
>    - Reworked initial DTS: moved idle-states / domain-idle-states inside
>      cpus{}, wrapped fixed clocks in a clocks{} container with peer node
>      names (xo-board, sleep-clk), dropped the pcie_pipe_clk fixed-clock
>      stub (the GCC 4th clock now uses <0> in DTS to match the sdx75
>      idiom; the YAML example uses a named placeholder), dropped the
>      RPMHPD_CX power-domain reference on GCC (Kuno GCC has no GDSCs /
>      no corner votes / no pm_runtime, so the reference was inert), and
>      added a bootloader hand-off comment on the memory node.
>    - Collected Acked-by / Reviewed-by tags from v1.
> - Link to v1: https://lore.kernel.org/all/20260809-kuno-soc-support-v1-0-5e0ede4a0c72@oss.qualcomm.com/
>
> ---
> Hardeep Sharma (2):
>        dt-bindings: soc: qcom,geni-se: Allow 1 or 2 address and size cells
>        ARM: dts: qcom: Add initial device tree for Kuno SoC
>
>   .../devicetree/bindings/soc/qcom/qcom,geni-se.yaml |   4 +-
>   arch/arm/boot/dts/qcom/Makefile                    |   1 +
>   arch/arm/boot/dts/qcom/qcom-kuno-idp.dts           |  25 ++
>   arch/arm/boot/dts/qcom/qcom-kuno.dtsi              | 444 +++++++++++++++++++++
>   4 files changed, 472 insertions(+), 2 deletions(-)
> ---
> base-commit: 6375e61c01e93e35ee7acd336a689ac1fae4b509
> change-id: 20260809-kuno-soc-support-1dab826de0bf
>
> Best regards,
> --
> Hardeep Sharma <hardeep.sharma at oss.qualcomm.com>

Hello All,

Hope you are doing well.

Could you please take a look at the following patch?

[PATCH v7 1/2] dt-bindings: soc: qcom,geni-se: Allow 1 or 2 address and 
size cells

https://lore.kernel.org/all/20260929-kuno-soc-support-v7-1-530f62dc4020@oss.qualcomm.com/

The DTS patch is ready to be picked up and applied. However, it depends 
on the DT-binding patch, which still requires review before the DTS 
change can be picked.

Your review of the DT-binding patch would be greatly appreciated to help 
move the series forward.

Best Wishes
Hardeep Sharma