[PATCH v26 06/10] power: reset: Add psci-reboot-mode driver

[Shivendra Pratap]

On 10/2/2026 7:00 PM, Bartosz Golaszewski wrote:
> On Mon, 28 Sep 2026 08:09:18 +0200, Shivendra Pratap
> <shivendra.pratap at oss.qualcomm.com> said:
>> PSCI supports different types of resets like SYSTEM_RESET, SYSTEM_RESET2
>> ARCH WARM reset and SYSTEM_RESET2 vendor-specific resets. Currently
>> there is no common driver that handles all supported psci resets at one
>> place. Additionally, there is no common mechanism to issue the supported
>> psci resets from userspace.
>>
>> Add psci-reboot-mode as an auxiliary device created by the psci-devices
>> driver. Define two types of PSCI resets, predefined-resets and
>> vendor-specific resets. Predefined-resets are defined by psci driver
>> and vendor-specific resets are defined by SoC vendors, under the
>> psci:reboot-mode node of SoC device tree.
>>
>> Register the driver with the reboot-mode framework to interface these
>> resets to userspace. When userspace initiates a supported command, pass
>> the reset arguments to the PSCI driver to enable command-based reset.
>>
>> This change allows userspace to issue supported PSCI reset commands
>> using the standard reboot system calls while enabling SoC vendors to
>> define their specific resets for PSCI.
>>
>> Suggested-by: Ulf Hansson <ulf.hansson at oss.qualcomm.com>
>> Suggested-by: Lee Jones <lee at kernel.org>
>> Suggested-by: Bartosz Golaszewski <bartosz.golaszewski at oss.qualcomm.com>
>> Signed-off-by: Shivendra Pratap <shivendra.pratap at oss.qualcomm.com>
>> ---
>>   MAINTAINERS                            |   1 +
>>   drivers/firmware/psci/psci-devices.c   |   4 ++
>>   drivers/power/reset/Kconfig            |  11 ++++
>>   drivers/power/reset/Makefile           |   1 +
>>   drivers/power/reset/psci-reboot-mode.c | 104 +++++++++++++++++++++++++++++++++
>>   5 files changed, 121 insertions(+)
>>
>> diff --git a/MAINTAINERS b/MAINTAINERS
>> index 70a11f2ff61d..1007d5cd2e13 100644
>> --- a/MAINTAINERS
>> +++ b/MAINTAINERS
>> @@ -22058,6 +22058,7 @@ L:	linux-arm-kernel at lists.infradead.org (moderated for non-subscribers)
>>   S:	Maintained
>>   F:	Documentation/devicetree/bindings/arm/psci.yaml
>>   F:	drivers/firmware/psci/
>> +F:	drivers/power/reset/psci-reboot-mode.c
>>   F:	include/linux/psci.h
>>   F:	include/uapi/linux/psci.h
>>
>> diff --git a/drivers/firmware/psci/psci-devices.c b/drivers/firmware/psci/psci-devices.c
>> index d23befc490ed..04f24b8d9943 100644
>> --- a/drivers/firmware/psci/psci-devices.c
>> +++ b/drivers/firmware/psci/psci-devices.c
>> @@ -20,6 +20,10 @@ static const struct arm_psci_device_info arm_psci_devices[] = {
>>   	{
>>   		.name = "psci-cpuidle-domain",
>>   	},
>> +	{
>> +		.name = "psci-reboot-mode",
>> +		.of_node_name = "reboot-mode",
>> +	},
>>   };
>>
>>   static void arm_psci_auxiliary_device_release(struct device *dev)
>> diff --git a/drivers/power/reset/Kconfig b/drivers/power/reset/Kconfig
>> index bce996bbef28..f165a41d40ed 100644
>> --- a/drivers/power/reset/Kconfig
>> +++ b/drivers/power/reset/Kconfig
>> @@ -360,6 +360,17 @@ config NVMEM_REBOOT_MODE
>>   	  then the bootloader can read it and take different
>>   	  action according to the mode.
>>
>> +config PSCI_REBOOT_MODE
>> +	bool "PSCI reboot mode driver"
>> +	depends on ARM_PSCI_DEVICES
>> +	select AUXILIARY_BUS
>> +	select REBOOT_MODE
>> +	help
>> +	  Say y here to enable the PSCI reboot mode driver. The driver
>> +	  registers with the reboot-mode framework to configure PSCI
>> +	  reset commands, which are executed by the PSCI driver during
>> +	  psci_sys_reset().
>> +
>>   config POWER_MLXBF
>>   	tristate "Mellanox BlueField power handling driver"
>>   	depends on (GPIO_MLXBF2 || GPIO_MLXBF3) && ACPI
>> diff --git a/drivers/power/reset/Makefile b/drivers/power/reset/Makefile
>> index e31cab4ba78e..45d8aaaffaa1 100644
>> --- a/drivers/power/reset/Makefile
>> +++ b/drivers/power/reset/Makefile
>> @@ -41,5 +41,6 @@ obj-$(CONFIG_REBOOT_MODE) += reboot-mode.o
>>   obj-$(CONFIG_SYSCON_REBOOT_MODE) += syscon-reboot-mode.o
>>   obj-$(CONFIG_POWER_RESET_SC27XX) += sc27xx-poweroff.o
>>   obj-$(CONFIG_NVMEM_REBOOT_MODE) += nvmem-reboot-mode.o
>> +obj-$(CONFIG_PSCI_REBOOT_MODE) += psci-reboot-mode.o
>>   obj-$(CONFIG_POWER_MLXBF) += pwr-mlxbf.o
>>   obj-$(CONFIG_POWER_RESET_QEMU_VIRT_CTRL) += qemu-virt-ctrl.o
>> diff --git a/drivers/power/reset/psci-reboot-mode.c b/drivers/power/reset/psci-reboot-mode.c
>> new file mode 100644
>> index 000000000000..bf2dd6626feb
>> --- /dev/null
>> +++ b/drivers/power/reset/psci-reboot-mode.c
>> @@ -0,0 +1,104 @@
>> +// SPDX-License-Identifier: GPL-2.0-only
>> +/*
>> + * Copyright (c) Qualcomm Technologies, Inc. and/or its subsidiaries.
>> + */
>> +
>> +#include <linux/array_size.h>
>> +#include <linux/auxiliary_bus.h>
>> +#include <linux/device.h>
>> +#include <linux/errno.h>
>> +#include <linux/init.h>
>> +#include <linux/kconfig.h>
> 
> Huh?

Thanks for review! Will remove these.

thanks,
Shivendra