[PATCH v1 1/7] ARM: dts: imx7d-colibri-emmc: Enable the VGA DAC

[Francesco Dolcini]

From: Emanuele Ghidoli <emanuele.ghidoli at toradex.com>

On the Colibri Evaluation Board and Aster carrier board, the BL_ON signal
on SODIMM 71 controls the active-low power-save input of the ADV7125 VGA
DAC. The VGA overlay does not drive this signal, leaving the DAC disabled.
The monitor receives the sync signals but displays a black image.
On the Iris carrier board, the DAC power-save input is pulled high
so the missing GPIO configuration does not prevent the VGA output from
working.

Add the pinctrl configuration and an active-high enable GPIO to the VGA
bridge so that the simple-bridge driver takes the DAC out of power-save
when enabling the output.

Fixes: cc6c96f0bdd7 ("ARM: dts: imx7d-colibri-emmc: Add VGA overlay")
Signed-off-by: Emanuele Ghidoli <emanuele.ghidoli at toradex.com>
Signed-off-by: Francesco Dolcini <francesco.dolcini at toradex.com>
---
 arch/arm/boot/dts/nxp/imx/imx7d-colibri-emmc-vga.dtso | 5 +++++
 1 file changed, 5 insertions(+)

diff --git a/arch/arm/boot/dts/nxp/imx/imx7d-colibri-emmc-vga.dtso b/arch/arm/boot/dts/nxp/imx/imx7d-colibri-emmc-vga.dtso
index cda214c13876..363c0c2cc43e 100644
--- a/arch/arm/boot/dts/nxp/imx/imx7d-colibri-emmc-vga.dtso
+++ b/arch/arm/boot/dts/nxp/imx/imx7d-colibri-emmc-vga.dtso
@@ -12,9 +12,14 @@
 /dts-v1/;
 /plugin/;
 
+#include <dt-bindings/gpio/gpio.h>
+
 &{/} {
 	vga-encoder {
 		compatible = "dumb-vga-dac";
+		pinctrl-names = "default";
+		pinctrl-0 = <&pinctrl_gpio_bl_on>;
+		enable-gpios = <&gpio5 1 GPIO_ACTIVE_HIGH>;
 
 		ports {
 			#address-cells = <1>;
-- 
2.47.3