[PATCH net-next v4 5/6] net: phy: mediatek: add calibration logic for AN7581

[Benjamin Larsson]

Hi.

On 04/11/2026 21:51, Andrew Lunn wrote:
>> It's safe in the measure that the worst is that link goes down during the
>> calibration... I will rework the function to assign the base address to the
>> default address for port 0 (it's hardcoded by the SoC) and use the lock and
>> read/write helper instead.
> 
> Are there multiple PHYs in the package? What happens if both are doing
> calibration at the same time?
> 
> PHY #0                            PHY #1
> 
> 
> phy_modify_mmd(phydev, devad, regnum, mask, cal_val);
> 
> 		       	      	  phy_modify_mmd(phydev, devad, regnum, mask, cal_val);
> 				  ret = mtk_cal_cycle_wait(phydev_p0);
> 
> ret = mtk_cal_cycle_wait(phydev_p0);
> 
>      Andrew

There are 4 phys in total, only the phy with mdio address 9 has the 
calibration capability. Thus only one phy at the time can perform the 
calibration sequence.

MvH
Benjamin Larsson