[PATCH] ARM: dts: bcm4709: fix bus range assignment

[Arnd Bergmann]

From: Arnd Bergmann <arnd at arndb.de>

The netgear r8000 dts file limits the bus range for the first host
bridge to exclude bus 0, but the two devices on the first bus are
explicitly assigned to bus 0, causing a build time warning:

/home/arnd/arm-soc/arch/arm/boot/dts/broadcom/bcm4709-netgear-r8000.dts:142.3-27: Warning (pci_device_bus_num): /axi at 18000000/pcie at 13000/pcie at 0/pcie at 0,0/pcie at 1,0:bus-range: PCI bus number 0 out of range, expected (1 - 255)
/home/arnd/arm-soc/arch/arm/boot/dts/broadcom/bcm4709-netgear-r8000.dts:142.3-27: Warning (pci_device_bus_num): /axi at 18000000/pcie at 13000/pcie at 0/pcie at 0,0/pcie at 2,0:bus-range: PCI bus number 0 out of range, expected (1 - 255)

I could not find any reason why this is done in the first place, but
this can be easily addressed by reassigning the two devices to
bus 1, or by dropping the bus-range property in order to allow
secondary bus 0 to be assigned.

Assuming the bus-range is intentional, fix this by moving the
devices to the first valid secondary bus number.

Fixes: 893faf67438c ("ARM: dts: BCM5301X: add root pcie bridges")
Signed-off-by: Arnd Bergmann <arnd at arndb.de>
---
 arch/arm/boot/dts/broadcom/bcm4709-netgear-r8000.dts | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/arch/arm/boot/dts/broadcom/bcm4709-netgear-r8000.dts b/arch/arm/boot/dts/broadcom/bcm4709-netgear-r8000.dts
index d170c71cbd76..355be5014943 100644
--- a/arch/arm/boot/dts/broadcom/bcm4709-netgear-r8000.dts
+++ b/arch/arm/boot/dts/broadcom/bcm4709-netgear-r8000.dts
@@ -147,7 +147,7 @@ pcie at 0,0 {
 
 		pcie at 1,0 {
 			device_type = "pci";
-			reg = <0x800 0 0 0 0>;
+			reg = <0x10800 0 0 0 0>;
 
 			#address-cells = <3>;
 			#size-cells = <2>;
@@ -162,7 +162,7 @@ wifi at 0,0 {
 
 		pcie at 2,0 {
 			device_type = "pci";
-			reg = <0x1000 0 0 0 0>;
+			reg = <0x11000 0 0 0 0>;
 
 			#address-cells = <3>;
 			#size-cells = <2>;
-- 
2.39.5