[PATCH] arm64: dts: imx8ulp-evk: Correct Type-C int GPIO flags

[Krzysztof Kozlowski]

IRQ_TYPE_xxx flags are not correct in the context of GPIO flags.
These are simple defines so they could be used in DTS but they will not
have the same meaning: IRQ_TYPE_EDGE_FALLING = 2 = GPIO_SINGLE_ENDED.

Correct the Type-C int-gpios to use proper flags, assuming the author of
the code wanted similar logical behavior:

  IRQ_TYPE_EDGE_FALLING => GPIO_ACTIVE_LOW

Fixes: c4b4593ecb0b ("arm64: dts: imx8ulp-evk: enable usb nodes and add ptn5150 nodes")
Cc: <stable at vger.kernel.org>
Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski at oss.qualcomm.com>
---
 arch/arm64/boot/dts/freescale/imx8ulp-evk.dts | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/arch/arm64/boot/dts/freescale/imx8ulp-evk.dts b/arch/arm64/boot/dts/freescale/imx8ulp-evk.dts
index 290a49bea2f7..5dea66c1e7aa 100644
--- a/arch/arm64/boot/dts/freescale/imx8ulp-evk.dts
+++ b/arch/arm64/boot/dts/freescale/imx8ulp-evk.dts
@@ -166,7 +166,7 @@ &lpi2c7 {
 	ptn5150_1: typec at 1d {
 		compatible = "nxp,ptn5150";
 		reg = <0x1d>;
-		int-gpios = <&gpiof 3 IRQ_TYPE_EDGE_FALLING>;
+		int-gpios = <&gpiof 3 GPIO_ACTIVE_LOW>;
 		pinctrl-names = "default";
 		pinctrl-0 = <&pinctrl_typec1>;
 		status = "disabled";
@@ -182,7 +182,7 @@ pcal6408: gpio at 21 {
 	ptn5150_2: typec at 3d {
 		compatible = "nxp,ptn5150";
 		reg = <0x3d>;
-		int-gpios = <&gpiof 5 IRQ_TYPE_EDGE_FALLING>;
+		int-gpios = <&gpiof 5 GPIO_ACTIVE_LOW>;
 		pinctrl-names = "default";
 		pinctrl-0 = <&pinctrl_typec2>;
 		status = "disabled";
-- 
2.51.0