[PATCH] ARM: dts: broadcom: rpi: Switch to V3D firmware clock

[Stefan Wahren]

Hi Mark,

Am 27.10.25 um 17:51 schrieb Mark Brown:
> On Mon, Oct 27, 2025 at 05:43:21PM +0100, Stefan Wahren wrote:
>> Am 27.10.25 um 13:07 schrieb Mark Brown:
>>> No.  This is happening in mainline (was originally reported against
>>> pending-fixes) so wasn't affected by all the module breakage, that was
>>> separate.
>> I think, i got confused because I was only able to reproduce this issue with
>> the broken linux-next. So I was going for the wrong cause :-(
>> Do you use arm64/defconfig as kernel config?
> Yes, it's just plain defconfig.
>
>> Is there a HDMI cable connected?
> No, the boards only have ethernet, serial and power connected.
I switched to the same Raspberry Pi firmware 2023-10-17 and added U-Boot 
2024.01 as second stage bootloader, but still not able to reproduce.

Looking at the LAVA output, I'm seeing this as the very first issue(s):

[   13.480675] platform wifi-pwrseq: deferred probe pending: 
pwrseq_simple: reset control not ready
[   13.489095] platform bcm2835-power: deferred probe pending: 
bcm2835-power: Failed to get clock v3d

Are critical drivers like clk_raspberrypi and resert_gpio listed in lsmod?

Is there anything special in the config.txt?

Regards