[PATCH 1/2] arm64: dts: imx8mm-phyboard-polis-rdk: Add USB1 OC pin configuration

[Teresa Remmet]

Add USB1 OC pin configuration for proper over-current detection.

Signed-off-by: Teresa Remmet <t.remmet at phytec.de>
---
 arch/arm64/boot/dts/freescale/imx8mm-phyboard-polis-rdk.dts | 8 ++++++++
 1 file changed, 8 insertions(+)

diff --git a/arch/arm64/boot/dts/freescale/imx8mm-phyboard-polis-rdk.dts b/arch/arm64/boot/dts/freescale/imx8mm-phyboard-polis-rdk.dts
index be470cfb03d7..35d8c5ab3547 100644
--- a/arch/arm64/boot/dts/freescale/imx8mm-phyboard-polis-rdk.dts
+++ b/arch/arm64/boot/dts/freescale/imx8mm-phyboard-polis-rdk.dts
@@ -285,6 +285,8 @@ &usbotg1 {
 	over-current-active-low;
 	samsung,picophy-pre-emp-curr-control = <3>;
 	samsung,picophy-dc-vol-level-adjust = <7>;
+	pinctrl-0 = <&pinctrl_usbotg1>;
+	pinctrl-names = "default";
 	srp-disable;
 	vbus-supply = <&reg_usb_otg1_vbus>;
 	status = "okay";
@@ -458,6 +460,12 @@ MX8MM_IOMUXC_GPIO1_IO12_GPIO1_IO12	0x00
 		>;
 	};
 
+	pinctrl_usbotg1: usbotg1grp {
+		fsl,pins = <
+			MX8MM_IOMUXC_GPIO1_IO13_USB1_OTG_OC	0x00
+		>;
+	};
+
 	pinctrl_usdhc1: usdhc1grp {
 		fsl,pins = <
 			MX8MM_IOMUXC_SD1_CLK_USDHC1_CLK		0x182

-- 
2.25.1