[PATCH v2 2/2] arm64: dts: rockchip: Add gmac phy reset GPIO

[Uwe Kleine-König]

While looking through the vendor U-Boot code Heiko spotted that a SoC
GPIO is connected to the ethernet phy's reset pin. Add the respective
reset-gpios property with pinmuxing for the GPIO to the phy node.

Signed-off-by: Uwe Kleine-König <uwe at kleine-koenig.org>
---
 arch/arm64/boot/dts/rockchip/rk3568-qnap-ts433.dts | 10 ++++++++++
 1 file changed, 10 insertions(+)

diff --git a/arch/arm64/boot/dts/rockchip/rk3568-qnap-ts433.dts b/arch/arm64/boot/dts/rockchip/rk3568-qnap-ts433.dts
index 70e88769e21c..411f8ac7994b 100644
--- a/arch/arm64/boot/dts/rockchip/rk3568-qnap-ts433.dts
+++ b/arch/arm64/boot/dts/rockchip/rk3568-qnap-ts433.dts
@@ -485,6 +485,10 @@ rgmii_phy0: ethernet-phy at 3 {
 		/* Motorcomm YT8521 phy */
 		compatible = "ethernet-phy-ieee802.3-c22";
 		reg = <0x3>;
+		pinctrl-0 = <&eth_phy0_reset_pin>;
+		pinctrl-names = "default";
+		reset-assert-us = <10000>;
+		reset-gpios = <&gpio0 RK_PC6 GPIO_ACTIVE_LOW>;
 	};
 };
 
@@ -557,6 +561,12 @@ &pcie3x2 {
 };
 
 &pinctrl {
+	gmac0 {
+		eth_phy0_reset_pin: eth-phy0-reset-pin {
+			rockchip,pins = <0 RK_PC6 RK_FUNC_GPIO &pcfg_pull_up>;
+		};
+	};
+
 	keys {
 		copy_button_pin: copy-button-pin {
 			rockchip,pins = <0 RK_PB6 RK_FUNC_GPIO &pcfg_pull_up>;
-- 
2.47.1