[PATCH v9 01/10] clk: qcom: clk-alpha-pll: Add support for dynamic update for slewing PLLs

[Konrad Dybcio]

On 6/25/25 12:31 PM, Taniya Das wrote:
> 
> 
> On 6/15/2025 12:20 AM, Konrad Dybcio wrote:
>> On 6/12/25 11:55 AM, Taniya Das wrote:
>>> The alpha PLLs which slew to a new frequency at runtime would require
>>> the PLL to calibrate at the mid point of the VCO. Add the new PLL ops
>>> which can support the slewing of the PLL to a new frequency.
>>>
>>> Reviewed-by: Imran Shaik <quic_imrashai at quicinc.com>
>>> Signed-off-by: Taniya Das <quic_tdas at quicinc.com>
>>> ---

[...]

>>> +	regmap_write(pll->clkr.regmap, PLL_L_VAL(pll), l);
>>> +	regmap_write(pll->clkr.regmap, PLL_ALPHA_VAL(pll), lower_32_bits(a));
>>> +	regmap_write(pll->clkr.regmap, PLL_ALPHA_VAL_U(pll), upper_32_bits(a));
>>> +
>>> +	/* Ensure that the write above goes before slewing the PLL */
>>> +	mb();
>>
>> Here however, the write may not arrive at the clock controller before you
>> proceed to slew_update()
>>
> 
> Yes, it is required here and will keep it.

You should change it to a readback instead

Konrad