[PATCH v9 07/10] clk: qcom: gpucc-qcs615: Add QCS615 graphics clock controller driver

Taniya Das quic_tdas at quicinc.com
Wed Jun 25 03:38:21 PDT 2025



On 6/15/2025 12:49 AM, Konrad Dybcio wrote:
> On 6/12/25 11:55 AM, Taniya Das wrote:
>> Add support for the graphics clock controller for graphics clients to
>> be able to request for the clocks on QCS615 platform.
>>
>> Reviewed-by: Dmitry Baryshkov <dmitry.baryshkov at linaro.org>
>> Signed-off-by: Taniya Das <quic_tdas at quicinc.com>
>> ---
> 
> [...]
> 
>> +struct clk_hw *gpu_cc_sm6150_hws[] = {
> 
> "wink"
> 

My bad.

> [...]
> 
>> +static void configure_crc(struct regmap *regmap)
>> +{
>> +	/* Recommended WAKEUP/SLEEP settings for the gpu_cc_cx_gmu_clk */
>> +	regmap_update_bits(regmap, gpu_cc_cx_gmu_clk.clkr.enable_reg, 0xff0, 0xff0);
>> +
>> +	/*
>> +	 * After POR, Clock Ramp Controller(CRC) will be in bypass mode.
>> +	 * Software needs to do the following operation to enable the CRC
>> +	 * for GFX3D clock and divide the input clock by div by 2.
>> +	 */
>> +	regmap_update_bits(regmap, 0x1028, 0x00015011, 0x00015011);
>> +	regmap_update_bits(regmap, 0x1024, 0x00800000, 0x00800000);
> 
> I'm going to assume this is not the same ramp controller as:
> 
> drivers/soc/qcom/ramp_controller.c
> 

This ramp controller is at the RCG level, which was very specific to
8976 and not same at the CC level.

> ..or maybe it is one, but we need to set things up on the CC
> side
> 
>> +}
>> +
>> +static int gpu_cc_qcs615_probe(struct platform_device *pdev)
>> +{
>> +	struct regmap *regmap;
>> +
>> +	regmap = qcom_cc_map(pdev, &gpu_cc_qcs615_desc);
>> +	if (IS_ERR(regmap))
>> +		return PTR_ERR(regmap);
>> +
>> +	clk_alpha_pll_configure(&gpu_cc_pll0, regmap, &gpu_cc_pll0_config);
>> +	clk_alpha_pll_configure(&gpu_cc_pll1, regmap, &gpu_cc_pll1_config);
>> +
>> +	/* Keep some clocks always enabled */
>> +	qcom_branch_set_clk_en(regmap, 0x1078); /* GPU_CC_AHB_CLK */
>> +
>> +	configure_crc(regmap);
> 
> Likewise, please rebase on Jagadeesh's series, which is now in
> linux-next. With that:
> 

I will fix them in the next patch series.

> Reviewed-by: Konrad Dybcio <konrad.dybcio at oss.qualcomm.com>
> 
> Konrad




More information about the linux-arm-kernel mailing list