[PATCH v9 07/10] clk: qcom: gpucc-qcs615: Add QCS615 graphics clock controller driver

[Konrad Dybcio]

On 6/12/25 11:55 AM, Taniya Das wrote:
> Add support for the graphics clock controller for graphics clients to
> be able to request for the clocks on QCS615 platform.
> 
> Reviewed-by: Dmitry Baryshkov <dmitry.baryshkov at linaro.org>
> Signed-off-by: Taniya Das <quic_tdas at quicinc.com>
> ---

[...]

> +struct clk_hw *gpu_cc_sm6150_hws[] = {

"wink"

[...]

> +static void configure_crc(struct regmap *regmap)
> +{
> +	/* Recommended WAKEUP/SLEEP settings for the gpu_cc_cx_gmu_clk */
> +	regmap_update_bits(regmap, gpu_cc_cx_gmu_clk.clkr.enable_reg, 0xff0, 0xff0);
> +
> +	/*
> +	 * After POR, Clock Ramp Controller(CRC) will be in bypass mode.
> +	 * Software needs to do the following operation to enable the CRC
> +	 * for GFX3D clock and divide the input clock by div by 2.
> +	 */
> +	regmap_update_bits(regmap, 0x1028, 0x00015011, 0x00015011);
> +	regmap_update_bits(regmap, 0x1024, 0x00800000, 0x00800000);

I'm going to assume this is not the same ramp controller as:

drivers/soc/qcom/ramp_controller.c

..or maybe it is one, but we need to set things up on the CC
side

> +}
> +
> +static int gpu_cc_qcs615_probe(struct platform_device *pdev)
> +{
> +	struct regmap *regmap;
> +
> +	regmap = qcom_cc_map(pdev, &gpu_cc_qcs615_desc);
> +	if (IS_ERR(regmap))
> +		return PTR_ERR(regmap);
> +
> +	clk_alpha_pll_configure(&gpu_cc_pll0, regmap, &gpu_cc_pll0_config);
> +	clk_alpha_pll_configure(&gpu_cc_pll1, regmap, &gpu_cc_pll1_config);
> +
> +	/* Keep some clocks always enabled */
> +	qcom_branch_set_clk_en(regmap, 0x1078); /* GPU_CC_AHB_CLK */
> +
> +	configure_crc(regmap);

Likewise, please rebase on Jagadeesh's series, which is now in
linux-next. With that:

Reviewed-by: Konrad Dybcio <konrad.dybcio at oss.qualcomm.com>

Konrad