[PATCH net-next v2 1/3] net: phy: mediatek: Add 2.5Gphy firmware dt-bindings and dts node

[Daniel Golle]

On Wed, Feb 19, 2025 at 04:26:21PM +0100, Andrew Lunn wrote:
> > +description: |
> > +  MediaTek Built-in 2.5G Ethernet PHY needs to load firmware so it can
> > +  run correctly.
> > +
> > +properties:
> > +  compatible:
> > +    const: "mediatek,2p5gphy-fw"
> > +
> > +  reg:
> > +    items:
> > +      - description: pmb firmware load address
> > +      - description: firmware trigger register
> > +
> > +required:
> > +  - compatible
> > +  - reg
> > +
> > +additionalProperties: false
> > +
> > +examples:
> > +  - |
> > +    phyfw: phy-firmware at f000000 {
> > +      compatible = "mediatek,2p5gphy-fw";
> > +      reg = <0 0x0f100000 0 0x20000>,
> > +            <0 0x0f0f0018 0 0x20>;
> > +    };
> 
> This is not a device in itself is it? There is no driver for this.
> 
> It seems like these should be properties in the PHY node, since it is
> the PHY driver which make use of them. This cannot be the first SoC
> device which is both on some sort of serial bus, but also has memory
> mapped registers.

I'm afraid it is...

> Please look around and find the correct way to do this.

Would using a 'reserved-memory' region be an option maybe?