[PATCH 2/2] arm64: dts: freescale: add initial device tree for TQMa8XxS

[Andrew Lunn]

> +&fec1 {
> +	pinctrl-names = "default";
> +	pinctrl-0 = <&pinctrl_fec1>;
> +	phy-mode = "rgmii-id";
> +	phy-handle = <&ethphy0>;
> +	fsl,magic-packet;
> +	mac-address = [ 00 00 00 00 00 00 ];
> +
> +	mdio {
> +		#address-cells = <1>;
> +		#size-cells = <0>;
> +
> +		ethphy0: ethernet-phy at 0 {
> +			compatible = "ethernet-phy-ieee802.3-c22";
> +			reg = <0>;
> +			pinctrl-names = "default";
> +			pinctrl-0 = <&pinctrl_ethphy0>;
> +			ti,rx-internal-delay = <DP83867_RGMIIDCTL_2_50_NS>;
> +			ti,tx-internal-delay = <DP83867_RGMIIDCTL_2_50_NS>;
> +			ti,fifo-depth = <DP83867_PHYCR_FIFO_DEPTH_4_B_NIB>;
> +			ti,dp83867-rxctrl-strap-quirk;
> +			ti,clk-output-sel = <DP83867_CLK_O_SEL_OFF>;
> +			reset-gpios = <&lsio_gpio3 22 GPIO_ACTIVE_LOW>;
> +			reset-assert-us = <500000>;
> +			reset-deassert-us = <50000>;
> +			enet-phy-lane-no-swap;
> +			interrupt-parent = <&lsio_gpio1>;
> +			interrupts = <30 IRQ_TYPE_EDGE_FALLING>;

EDGE_FALLING is very likely to be wrong. PHYs are generally level
triggered, not edge.

	Andrew