[PATCH v3 2/4] arm64: defconfig: enable clock controller, interconnect and pinctrl for QCS8300

[Dmitry Baryshkov]

On Thu, Nov 28, 2024 at 04:44:44PM +0800, Jingyi Wang wrote:
> Enable clock controller, interconnect and pinctrl for Qualcomm
> QCS8300 platform to boot to UART console.

... which is used on the ABC DEF board. The defconfig is being enabled
for everybody, so at least let them know which board increases the size
of the default kernel build.

> 
> The serial engine depends on gcc, interconnect and pinctrl. Since
> the serial console driver is only available as built-in, so these
> configs needs be built-in for the UART device to probe and register
> the console.
> 
> Reviewed-by: Krzysztof Kozlowski <krzk at kernel.org>
> Signed-off-by: Jingyi Wang <quic_jingyw at quicinc.com>
> ---
>  arch/arm64/configs/defconfig | 3 +++
>  1 file changed, 3 insertions(+)
> 
> diff --git a/arch/arm64/configs/defconfig b/arch/arm64/configs/defconfig
> index d13218d0c30f..3d9e48940c96 100644
> --- a/arch/arm64/configs/defconfig
> +++ b/arch/arm64/configs/defconfig
> @@ -608,6 +608,7 @@ CONFIG_PINCTRL_MSM8996=y
>  CONFIG_PINCTRL_MSM8998=y
>  CONFIG_PINCTRL_QCM2290=y
>  CONFIG_PINCTRL_QCS404=y
> +CONFIG_PINCTRL_QCS8300=y
>  CONFIG_PINCTRL_QDF2XXX=y
>  CONFIG_PINCTRL_QDU1000=y
>  CONFIG_PINCTRL_SA8775P=y
> @@ -1327,6 +1328,7 @@ CONFIG_MSM_MMCC_8998=m
>  CONFIG_QCM_GCC_2290=y
>  CONFIG_QCM_DISPCC_2290=m
>  CONFIG_QCS_GCC_404=y
> +CONFIG_QCS_GCC_8300=y
>  CONFIG_SC_CAMCC_7280=m
>  CONFIG_QDU_GCC_1000=y
>  CONFIG_SC_CAMCC_8280XP=m
> @@ -1634,6 +1636,7 @@ CONFIG_INTERCONNECT_QCOM_MSM8996=y
>  CONFIG_INTERCONNECT_QCOM_OSM_L3=m
>  CONFIG_INTERCONNECT_QCOM_QCM2290=y
>  CONFIG_INTERCONNECT_QCOM_QCS404=m
> +CONFIG_INTERCONNECT_QCOM_QCS8300=y
>  CONFIG_INTERCONNECT_QCOM_QDU1000=y
>  CONFIG_INTERCONNECT_QCOM_SA8775P=y
>  CONFIG_INTERCONNECT_QCOM_SC7180=y
> 
> -- 
> 2.25.1
> 

-- 
With best wishes
Dmitry