[PATCH v2 0/3] dt-bindings: arm: bcm: raspberrypi,bcm2835-firmware: Drive-by fixes

[Laurent Pinchart]

Hello,

This small series includes a few drive-by fixes for DT validation
errors.

The first patch has been posted previously in v1 ([1], and now addresses
a small review comment. I think it's good to go.

The next two patches address the same issue as "[PATCH 1/2] dt-bindings:
arm: bcm: raspberrypi,bcm2835-firmware: Add missing properties" ([2]),
but this time with a (hopefully) correct approach. Patch 2/3 starts by
fixing the raspberrypi-bcm2835-firmware driver, removing the need for DT
properties that are specified in bcm2835-rpi.dtsi but not documented in
the corresponding bindings. Patch 3/3 can then drop those properties,
getting rid of the warnings.

[1] https://lore.kernel.org/linux-arm-kernel/20240326004902.17054-3-laurent.pinchart@ideasonboard.com/
[2] https://lore.kernel.org/linux-arm-kernel/20240326004902.17054-2-laurent.pinchart@ideasonboard.com/

Laurent Pinchart (3):
  dt-bindings: arm: bcm: raspberrypi,bcm2835-firmware: Add gpio child
    node
  firmware: raspberrypi: Use correct device for DMA mappings
  ARM: dts: bcm283x: Drop unneeded properties in the bcm2835-firmware
    node

 .../arm/bcm/raspberrypi,bcm2835-firmware.yaml | 30 +++++++++++++++++++
 .../gpio/raspberrypi,firmware-gpio.txt        | 30 -------------------
 arch/arm/boot/dts/broadcom/bcm2835-rpi.dtsi   |  4 ---
 drivers/firmware/raspberrypi.c                |  7 +++--
 4 files changed, 34 insertions(+), 37 deletions(-)
 delete mode 100644 Documentation/devicetree/bindings/gpio/raspberrypi,firmware-gpio.txt

-- 
Regards,

Laurent Pinchart