[PATCH 03/11] arm64: dts: ti: k3-j7200: Convert serdes_ln_ctrl node into reg-mux

[Andrew Davis]

This removes a dependency on the parent node being a syscon node.
Convert from mmio-mux to reg-mux adjusting node name and properties
as needed.

Signed-off-by: Andrew Davis <afd at ti.com>
---
 arch/arm64/boot/dts/ti/k3-j7200-main.dtsi | 7 ++++---
 1 file changed, 4 insertions(+), 3 deletions(-)

diff --git a/arch/arm64/boot/dts/ti/k3-j7200-main.dtsi b/arch/arm64/boot/dts/ti/k3-j7200-main.dtsi
index da67bf8fe703e..50d1f173bde31 100644
--- a/arch/arm64/boot/dts/ti/k3-j7200-main.dtsi
+++ b/arch/arm64/boot/dts/ti/k3-j7200-main.dtsi
@@ -33,10 +33,11 @@ scm_conf: scm-conf at 100000 {
 		ranges = <0x00 0x00 0x00100000 0x1c000>;
 
 		serdes_ln_ctrl: mux-controller at 4080 {
-			compatible = "mmio-mux";
+			compatible = "reg-mux";
+			reg = <0x4080 0x20>;
 			#mux-control-cells = <1>;
-			mux-reg-masks = <0x4080 0x3>, <0x4084 0x3>, /* SERDES0 lane0/1 select */
-					<0x4088 0x3>, <0x408c 0x3>; /* SERDES0 lane2/3 select */
+			mux-reg-masks = <0x0 0x3>, <0x4 0x3>, /* SERDES0 lane0/1 select */
+					<0x8 0x3>, <0xc 0x3>; /* SERDES0 lane2/3 select */
 		};
 
 		cpsw0_phy_gmii_sel: phy at 4044 {
-- 
2.39.2