[PATCH v6 1/2] tty: serial: Cleanup the bit shift with macro

[Christoph Niedermaier]

Hi everyone,

> This patch replaces the bit shift code with "_BITUL()" macro inside
> "serial_rs485" struct.
> 
> Signed-off-by: Crescent CY Hsieh <crescentcy.hsieh at moxa.com>
> ---
>  include/uapi/linux/serial.h | 17 +++++++++--------
>  1 file changed, 9 insertions(+), 8 deletions(-)
> 
> diff --git a/include/uapi/linux/serial.h b/include/uapi/linux/serial.h
> index 53bc1af67..6c75ebdd7 100644
> --- a/include/uapi/linux/serial.h
> +++ b/include/uapi/linux/serial.h
> @@ -11,6 +11,7 @@
>  #ifndef _UAPI_LINUX_SERIAL_H
>  #define _UAPI_LINUX_SERIAL_H
>  
> +#include <linux/const.h>
>  #include <linux/types.h>
>  
>  #include <linux/tty_flags.h>
> @@ -140,14 +141,14 @@ struct serial_icounter_struct {
>   */
>  struct serial_rs485 {
>  	__u32	flags;
> -#define SER_RS485_ENABLED		(1 << 0)
> -#define SER_RS485_RTS_ON_SEND		(1 << 1)
> -#define SER_RS485_RTS_AFTER_SEND	(1 << 2)

In the old definition (1 << 3) wasn't used.

> -#define SER_RS485_RX_DURING_TX		(1 << 4)
> -#define SER_RS485_TERMINATE_BUS		(1 << 5)
> -#define SER_RS485_ADDRB			(1 << 6)
> -#define SER_RS485_ADDR_RECV		(1 << 7)
> -#define SER_RS485_ADDR_DEST		(1 << 8)
> +#define SER_RS485_ENABLED		_BITUL(0)
> +#define SER_RS485_RTS_ON_SEND		_BITUL(1)
> +#define SER_RS485_RTS_AFTER_SEND	_BITUL(2)
> +#define SER_RS485_RX_DURING_TX		_BITUL(3)

Isn't it a break if number 3 isn't skipped here as well?

Regards
Christoph