[PATCH v2 2/3] pmdomain: imx93-pd: don't unprepare clocks on driver remove

[Dario Binacchi]

The removed code was added to handle the case where the power domain is
already on during the driver's probing. In this use case, the "is_off"
parameter is passed as false to pm_genpd_init() to inform it not to call
the power_on() callback, as it's unnecessary to perform the hardware
power-on procedure since the power domain is already on. Therefore, with
the call to clk_bulk_prepare_enable() by probe(), the system is in the
same operational state as when "is_off" is passed as true after the
power_on() callback execution:

 probe() -> is_off == true  -> clk_bulk_prepare_enable() called by power_on()
 probe() -> is_off == false -> clk_bulk_prepare_enable() called by probe()

Reaching the same logical and operational state, it follows that upon
driver removal, there is no need to perform different actions depending
on the power domain's on/off state during probing.

Signed-off-by: Dario Binacchi <dario.binacchi at amarulasolutions.com>
---

(no changes since v1)

 drivers/pmdomain/imx/imx93-pd.c | 3 ---
 1 file changed, 3 deletions(-)

diff --git a/drivers/pmdomain/imx/imx93-pd.c b/drivers/pmdomain/imx/imx93-pd.c
index 44daecbe5cc3..fb53a8e359bc 100644
--- a/drivers/pmdomain/imx/imx93-pd.c
+++ b/drivers/pmdomain/imx/imx93-pd.c
@@ -90,9 +90,6 @@ static void imx93_pd_remove(struct platform_device *pdev)
 	struct device *dev = &pdev->dev;
 	struct device_node *np = dev->of_node;
 
-	if (!domain->init_off)
-		clk_bulk_disable_unprepare(domain->num_clks, domain->clks);
-
 	of_genpd_del_provider(np);
 	pm_genpd_remove(&domain->genpd);
 }
-- 
2.43.0