[PATCH] arm64: dts: ti: k3-am68-sk-base-board: Add clklb pin mux for mmc1

[Bhavya Kapoor]

Hi Neha,

On 08/08/24 11:51 am, Neha Malcom Francis wrote:
> Hi Bhavya
>
> On 07/08/24 15:46, Bhavya Kapoor wrote:
>> mmc1 was not functional since pin mux for clklb was not present.
>> Thus, add clklb pin mux to get MMC working.
>>
>> Fixes: a266c180b398 ("arm64: dts: ti: k3-am68-sk: Add support for 
>> AM68 SK base board")
>> Signed-off-by: Bhavya Kapoor <b-kapoor at ti.com>
>> ---
>>
>> rebased to next-20240807
>>
>>   arch/arm64/boot/dts/ti/k3-am68-sk-base-board.dts | 1 +
>>   1 file changed, 1 insertion(+)
>>
>> diff --git a/arch/arm64/boot/dts/ti/k3-am68-sk-base-board.dts 
>> b/arch/arm64/boot/dts/ti/k3-am68-sk-base-board.dts
>> index 90dbe31c5b81..d5ceab79536c 100644
>> --- a/arch/arm64/boot/dts/ti/k3-am68-sk-base-board.dts
>> +++ b/arch/arm64/boot/dts/ti/k3-am68-sk-base-board.dts
>> @@ -204,6 +204,7 @@ main_mmc1_pins_default: main-mmc1-default-pins {
>>           pinctrl-single,pins = <
>>               J721S2_IOPAD(0x104, PIN_INPUT, 0) /* (P23) MMC1_CLK */
>>               J721S2_IOPAD(0x108, PIN_INPUT, 0) /* (N24) MMC1_CMD */
>> +            J721S2_IOPAD(0x100, PIN_INPUT, 0) /* (###) MMC1_CLKLB */
>>               J721S2_IOPAD(0x0fc, PIN_INPUT, 0) /* (M23) MMC1_DAT0 */
>>               J721S2_IOPAD(0x0f8, PIN_INPUT, 0) /* (P24) MMC1_DAT1 */
>>               J721S2_IOPAD(0x0f4, PIN_INPUT, 0) /* (R24) MMC1_DAT2 */
>
> How is this different from the P23 pinmux for MMC1_CLK? Could you 
> explain what CLKLB is, since it doesn't have a ball number I'm finding 
> it difficult to understand what it is?
>
This pin needs to be setup so that MMC_CLK is looped back at pad level 
for highspeed SDIO operations (has been same across K3 family). MMC0/1 
has this pin configured as INPUT by reset default as these have boot media

  These pinmuxes are derived from pinmux file shared by EVM team during 
wakeup/board bringup.

Regards