[PATCH v2] arm: dts: bcm2711: Describe Ethernet LEDs

[Rob Herring]

On Mon, 22 Apr 2024 16:08:09 -0700, Florian Fainelli wrote:
> Describe the Ethernet LEDs for the Raspberry Pi 4 model B board as well
> as the Raspberry Pi 4 CM board. The Raspberry Pi 400 board does not
> include RJ45 connector LEDs so the 'leds' node is deleted accordingly.
> 
> Signed-off-by: Florian Fainelli <florian.fainelli at broadcom.com>
> ---
> Changes in v2:
> 
> - added "function = LED_FUNCTION_LAN"
> 
>  .../arm/boot/dts/broadcom/bcm2711-rpi-4-b.dts | 20 +++++++++++++++++
>  .../arm/boot/dts/broadcom/bcm2711-rpi-400.dts |  1 +
>  .../boot/dts/broadcom/bcm2711-rpi-cm4-io.dts  | 22 +++++++++++++++++++
>  3 files changed, 43 insertions(+)
> 


My bot found new DTB warnings on the .dts files added or changed in this
series.

Some warnings may be from an existing SoC .dtsi. Or perhaps the warnings
are fixed by another series. Ultimately, it is up to the platform
maintainer whether these warnings are acceptable or not. No need to reply
unless the platform maintainer has comments.

If you already ran DT checks and didn't see these error(s), then
make sure dt-schema is up to date:

  pip3 install dtschema --upgrade


New warnings running 'make CHECK_DTBS=y broadcom/bcm2711-rpi-4-b.dtb broadcom/bcm2711-rpi-400.dtb broadcom/bcm2711-rpi-cm4-io.dtb' for 20240422230811.1284092-1-florian.fainelli at broadcom.com:

arch/arm/boot/dts/broadcom/bcm2711-rpi-4-b.dtb: ethernet-phy at 1: leds: 'leds at 0', 'leds at 1' do not match any of the regexes: '^led@[a-f0-9]+$', 'pinctrl-[0-9]+'
	from schema $id: http://devicetree.org/schemas/net/ethernet-phy.yaml#
arch/arm/boot/dts/broadcom/bcm2711-rpi-400.dtb: ethernet-phy at 1: leds: 'leds at 0', 'leds at 1' do not match any of the regexes: '^led@[a-f0-9]+$', 'pinctrl-[0-9]+'
	from schema $id: http://devicetree.org/schemas/net/ethernet-phy.yaml#
arch/arm/boot/dts/broadcom/bcm2711-rpi-cm4-io.dtb: ethernet-phy at 0: leds: 'leds at 1', 'leds at 2' do not match any of the regexes: '^led@[a-f0-9]+$', 'pinctrl-[0-9]+'
	from schema $id: http://devicetree.org/schemas/net/ethernet-phy.yaml#