[RFT PATCH v2 10/10] arm64: dts: microchip: sparx5_pcb135: drop duplicated NOR flash

[Krzysztof Kozlowski]

Since beginning the DTS extended the SPI0 in two places adding two SPI
muxes, each with same SPI NOR flash.  Both used exactly the same
chip-selects, so this was clearly buggy code.  Then in commit
d0f482bb06f9 ("arm64: dts: sparx5: Add the Sparx5 switch node") one SPI
mux was removed, while keeping the SPI NOR flash node.

This still leaves duplicated SPI nodes under same chip select 0,
reported by dtc W=1 warnings:

  sparx5_pcb135_board.dtsi:92.10-96.4: Warning (unique_unit_address_if_enabled): /axi at 600000000/spi at 600104000/flash at 0: duplicate unit-address (also used in node /axi at 600000000/spi at 600104000/spi at 0)

Steen Hegelund confirmed that in fact there is a SPI mux, thus remove
the duplicated node without the mux.

Signed-off-by: Krzysztof Kozlowski <krzk at kernel.org>

---

Not tested on hardware

Changes in v2:
1. Remove SPI node without mux.
---
 arch/arm64/boot/dts/microchip/sparx5_pcb135_board.dtsi | 9 ---------
 1 file changed, 9 deletions(-)

diff --git a/arch/arm64/boot/dts/microchip/sparx5_pcb135_board.dtsi b/arch/arm64/boot/dts/microchip/sparx5_pcb135_board.dtsi
index 20016efb3656..af2f1831f07f 100644
--- a/arch/arm64/boot/dts/microchip/sparx5_pcb135_board.dtsi
+++ b/arch/arm64/boot/dts/microchip/sparx5_pcb135_board.dtsi
@@ -87,15 +87,6 @@ i2cmux_s32: i2cmux-3-pins {
 	};
 };
 
-&spi0 {
-	status = "okay";
-	flash at 0 {
-		compatible = "jedec,spi-nor";
-		spi-max-frequency = <8000000>;
-		reg = <0>;
-	};
-};
-
 &spi0 {
 	status = "okay";
 	spi at 0 {
-- 
2.34.1